EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

3D-Printed Polymer Waveguides for Spatially Redistributing Light

Sarah Ansert, Yijie Cheng, Akhiri Zannat, Xinyue Liu

ACS Materials Au · 13.04.2026

DOI: 10.1021/acsmaterialsau.5c00251 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Materials Au, online erschienen am 13.04.2026. Verfasst von Sarah Ansert und 3 weiteren Autor:innen. Die Arbeit nennt 54 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Division of Chemical, Bioengineering, Environmental, and Transport Systems, College of Engineering, Michigan State University.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Conventional silica-based optical fibers provide one-dimensional (1D) point-to-point light transmission, enabling illumination only at the distal end and offering limited control over the spatial distribution of light intensity. In contrast, three-dimensional (3D) waveguide architectures have the potential to convert a single-point input into multipoint, spatially distributed illumination, enabling volumetric light–matter interactions. However, fabrication of optically transparent silica waveguides with complex 3D geometries remains challenging due to material constraints and manufacturing complexity. In this work, a wide range of polymer waveguide architectures are designed and fabricated using commercially available stereolithographic (SLA) 3D printing. Optical characterization demonstrates high transparency and effective light confinement in the printed polymer materials. We identify postprint surface finishing as a primary factor governing light transmission efficiency, achieving a 3.6-fold increase in transmittance compared to unfinished prints. In addition, geometric parameters were systematically investigated to determine their impact on light preservation. Smaller diameters, shorter lengths, reduced branching angles, and smoothly curved junctions are found to minimize optical losses in Y-shaped waveguide architectures. Building on these design principles, we further demonstrate that multibranch and multilayer architectures enable uniform light distribution in both linear and planar configurations. These 3D-printed multibranch waveguides provide a general strategy for efficient light delivery in light-absorbing environments. As a representative application, embedding multibranch waveguides within dense microalgal cultures redistributed light throughout the strongly absorbing aquatic environment, mitigating light attenuation and enhancing biomass productivity. These results together establish a geometry-engineered optical redistribution platform that enables 3D spatial light delivery beyond conventional point-to-point waveguiding.

Förderung

  • Division of Chemical, Bioengineering, Environmental, and Transport Systems
  • College of Engineering, Michigan State University

Zitieren

APA

Ansert, S., Cheng, Y., Zannat, A., & Liu, X. (2026). 3D-Printed Polymer Waveguides for Spatially Redistributing Light. ACS Materials Au. https://doi.org/10.1021/acsmaterialsau.5c00251

Vancouver

Ansert S, Cheng Y, Zannat A, Liu X. 3D-Printed Polymer Waveguides for Spatially Redistributing Light. ACS Materials Au. 2026. doi:10.1021/acsmaterialsau.5c00251

BibTeX
@article{Ansert2026,
  author = {Ansert, Sarah and Cheng, Yijie and Zannat, Akhiri and Liu, Xinyue},
  title = {3D-Printed Polymer Waveguides for Spatially Redistributing Light},
  journal = {ACS Materials Au},
  year = {2026},
  doi = {10.1021/acsmaterialsau.5c00251}
}
Kostenlos starten →