Influence of different evaluation pastes on the bond of resin cement to lithium disilicate ceramic: An in vitro study
The Journal of Prosthetic Dentistry · 2025
DOI: 10.1016/j.prosdent.2025.10.031 ↗Kurz gefasst
Fachartikel in der Zeitschrift The Journal of Prosthetic Dentistry, 2025. Verfasst von Catina Prochnow und 7 weiteren Autor:innen. Beteiligte Einrichtung: Postdoctoral student, Postgraduate Program in Oral Sciences (Prosthodontics Units), Faculty of Dentistry, Federal University of Santa Maria (UFSM), S…. Hauptthemen laut MEDLINE: Dental Porcelain, Resin Cements, Dental Bonding, Ceramics. Die Arbeit nennt 38 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Coordination for the improvement of Higher Education Personnel, National Council for Scientific and Technological Development.
Abstract (Originalsprache)
STATEMENT OF PROBLEM: Residue from evaluation pastes may remain on the bonding surface of indirect restorations, requiring specific cleaning protocols. However, it is not clear how much the composition of different evaluation pastes affects the bond strength to resin cement. PURPOSE: The purpose of this in vitro study was to determine the effectiveness of using 37% phosphoric acid to clean different evaluation pastes and its effect on the long-term bond strength of lithium disilicate ceramics to resin cement. MATERIAL AND METHODS: Lithium disilicate slices (IPS e.max CAD) with simulated computer-aided design and computer-aided manufacturing (CAD-CAM) topography were crystallized, etched (20 seconds - 5% hydrofluoric acid -HF), and received the application of different evaluation pastes (CTRL - no contamination; AC - Allcem; NX - NX3; ML - Multilink; RX - RelyX). All specimens were actively cleaned for 60 seconds with 37% phosphoric acid, except for the CTRL group. After applying silane, resin cement cylinders were produced and light-polymerized. Micro-shear bond strength testing was carried out on half of the cylinders (n=40) at baseline (24 hours) and after aging (220 days of water storage at 37 °C and 25 000 heat cycles between 5 °C and 55 °C). Failure modes, surface topography via scanning electron microscopy (SEM), and chemical composition through energy-dispersive X-ray spectroscopy (EDS) were assessed. Statistical analysis used 2-way analysis of variance (ANOVA) and Bonferroni post hoc tests (α=.05). RESULTS: At baseline, the AC and NX groups exhibited bond strength similar to the CTRL group. All groups experienced a considerable decline in bond strength after aging, but there was no difference between the AC group and the CTRL group. In both scenarios, the RX and ML groups displayed the weakest bonds. SEM analysis revealed similar surface topography, confirming the EDS results, where similar elemental composition was observed among the groups. CONCLUSIONS: Cleaning lithium disilicate surfaces with 37% phosphoric acid after contamination with an evaluation paste is not universally effective for the tested pastes. Some pastes leave a residue that still compromises bond strength in the long term. Therefore, alternative cleaning methods should be considered.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Substanzen
Autor:innen und Institutionen
- Postdoctoral student, Postgraduate Program in Oral Sciences (Prosthodontics Units), Faculty of Dentistry, Federal University of Santa Maria (UFSM), Santa Maria, RS, Brazil. Electronic address: catinaprochnow@hotmail.com.
- Postgraduate student, Postgraduate Program in Oral Sciences (Prosthodontics Units), Faculty of Dentistry, Federal University of Santa Maria (UFSM), Santa Maria, RS, Brazil. Electronic address: duvancala@gmail.com.
- Adjunct Professor, Faculty of Dentistry, Federal University of Rio Grande do Sul (UFRGS), Porto Alegre, RS, Brazil. Electronic address: rafaela-pilecco@hotmail.com.
- Assistant Professor, Department of Dental Materials Science, Academic Centre for Dentistry Amsterdam (ACTA), Universiteit van Amsterdam and Vrije Universiteit, Amsterdam, North Holland, The Netherlands. Electronic addre…
- Assistant Professor, Department of Reconstructive Oral Care, Academic Centre for Dentistry Amsterdam (ACTA), Universiteit van Amsterdam and Vrije Universiteit, Amsterdam, North Holland, The Netherlands. Electronic addre…
- Full Professor, Department of Restorative Dentistry, Postgraduate Program in Oral Sciences (Prosthodontics Units), Faculty of Dentistry, Federal University of Santa Maria (UFSM), Santa Maria, RS, Brazil. Electronic addr…
Förderung
- Coordination for the improvement of Higher Education Personnel
- National Council for Scientific and Technological Development
Zitieren
APA
Prochnow, C., Castillo, D. C., Pilecco, R. O., Dal Piva, A. M. O., Tribst, J. P. M., Valandro, L. F., Moraes, R. R., & Pereira, G. K. R. (2025). Influence of different evaluation pastes on the bond of resin cement to lithium disilicate ceramic: An in vitro study. The Journal of Prosthetic Dentistry. https://doi.org/10.1016/j.prosdent.2025.10.031
Vancouver
Prochnow C, Castillo DC, Pilecco RO, Dal Piva AMO, Tribst JPM, Valandro LF, et al. Influence of different evaluation pastes on the bond of resin cement to lithium disilicate ceramic: An in vitro study. The Journal of Prosthetic Dentistry. 2025. doi:10.1016/j.prosdent.2025.10.031
BibTeX
@article{Prochnow2025,
author = {Prochnow, Catina and Castillo, Duvan Cala and Pilecco, Rafaela Oliveira and Dal Piva, Amanda Maria de Oliveira and Tribst, João Paulo Mendes and Valandro, Luiz Felipe and Moraes, Rafael Ratto de and Pereira, Gabriel Kalil Rocha},
title = {Influence of different evaluation pastes on the bond of resin cement to lithium disilicate ceramic: An in vitro study},
journal = {The Journal of Prosthetic Dentistry},
year = {2025},
doi = {10.1016/j.prosdent.2025.10.031}
}
EUVIMED