EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Determining the strength of 3D printed concrete with the modified slant shear test

Lucia Licciardello, Alejandro Giraldo Soto, Walter Kaufmann, Giovanni Metelli

Structural Concrete · 2025-06 · 26 (3) · 2467-2486

DOI: 10.1002/suco.202400238 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Structural Concrete, online erschienen am 12.01.2025. Verfasst von Lucia Licciardello und 3 weiteren Autor:innen. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 53 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Schweizerischer Nationalfonds zur Förderung der Wissenschaftlichen Forschung, Università degli Studi di Brescia.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study deals with the assessment of the load‐bearing capacity of layered 3D printed concrete (3DPC) using a modified slant shear test (MSST) to define a Mohr's envelope. To this aim, the established modified Coulomb yield condition of the concrete is complemented by a Coulomb failure criterion of the layer joints (cold or dry joints). Due to the anisotropy inherent to 3DPC elements, caused by the interlayer of printed concrete, the test setups commonly used for conventional concrete are inadequate to assess the load‐bearing capacity of 3DPC. A total of 45 3DPC specimens with different inclinations of the concrete printed layers, including a cold joint with 30 min time gap were tested using the MSST. The results showed a high strength of the interfaces with two different failure modes, depending on the inclination of the layers: (i) concrete matrix failure and (ii) layer interface failure, where the latter governed for layer inclinations of 60° and 75° with respect to the horizontal plane. The test campaign confirms that the proposed MSST is a highly practical test method that enables determining the parameters governing a Mohr's envelope of layered 3DPC and can thus be used to reliably characterize its load‐bearing capacity.

Förderung

  • Schweizerischer Nationalfonds zur Förderung der Wissenschaftlichen Forschung
  • Università degli Studi di Brescia

Zitieren

APA

Licciardello, L., Soto, A. G., Kaufmann, W., & Metelli, G. (2025). Determining the strength of 3D printed concrete with the modified slant shear test. Structural Concrete, 26(3), 2467-2486. https://doi.org/10.1002/suco.202400238

Vancouver

Licciardello L, Soto AG, Kaufmann W, Metelli G. Determining the strength of 3D printed concrete with the modified slant shear test. Structural Concrete. 2025;26(3):2467-2486. doi:10.1002/suco.202400238

BibTeX
@article{Licciardello2025,
  author = {Licciardello, Lucia and Soto, Alejandro Giraldo and Kaufmann, Walter and Metelli, Giovanni},
  title = {Determining the strength of 3D printed concrete with the modified slant shear test},
  journal = {Structural Concrete},
  year = {2025},
  volume = {26},
  number = {3},
  pages = {2467--2486},
  doi = {10.1002/suco.202400238}
}
Kostenlos starten →