Interlayer Bond Strength of 3D Printed Concrete Members with Ultra High Performance Concrete (UHPC) Mix
Buildings · 05.07.2024 · 14 (7) · 2060
DOI: 10.3390/buildings14072060 ↗Kurz gefasst
Fachartikel in der Zeitschrift Buildings, online erschienen am 05.07.2024. Verfasst von Yoon Jung Lee und 5 weiteren Autor:innen. Die Arbeit wurde bisher 28-mal zitiert (Crossref) und nennt 60 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Research Foundation of Korea (NRF), Korea Ministry of Land, Infrastructure and Transport (MOLIT).
Abstract (Originalsprache)
In structures manufactured using 3D concrete printing, cracks can easily propagate along the interface between printed layers. Therefore, it was necessary to determine the interlayer bond strength. In this study, direct shear and tensile tests were performed to determine the interlayer bond stability of the 3DCP members. To confirm the appropriateness of the mix proportion used to fabricate the specimens, the open time available for printing was identified via a mixing test, and the extrudability and buildability were verified via a printing test. In addition, direct shear and tensile tests were performed using the specimen manufacturing method (i.e., mold casting and 3D printing) and printing time gap (PTG) between the laminated layers as key test variables. The interlayer bond strengths of the specimens, according to the variables obtained from the test results, were compared and analyzed based on the interfacial shear strength standards presented in the current structural codes. In the direct shear test, failure occurred at the interlayers of all the specimens, and the interlayer bond strength tended to decrease with increasing PTG. In addition, the interlayer bond strength of the direct shear specimens exceeded the interfacial shear strength suggested by current structural codes. In contrast, in the direct tensile test, interlayer surface failure occurred only in some specimens, and there was no distinct change in the interlayer bond strength owing to PTG.
Förderung
- National Research Foundation of Korea (NRF)
- Korea Ministry of Land, Infrastructure and Transport (MOLIT)
Zitieren
APA
Lee, Y. J., Lee, S., Kim, J. H., Jeong, H., Han, S., & Kim, K. S. (2024). Interlayer Bond Strength of 3D Printed Concrete Members with Ultra High Performance Concrete (UHPC) Mix. Buildings, 14(7), 2060. https://doi.org/10.3390/buildings14072060
Vancouver
Lee YJ, Lee S, Kim JH, Jeong H, Han S, Kim KS. Interlayer Bond Strength of 3D Printed Concrete Members with Ultra High Performance Concrete (UHPC) Mix. Buildings. 2024;14(7):2060. doi:10.3390/buildings14072060
BibTeX
@article{Lee2024,
author = {Lee, Yoon Jung and Lee, Sang-Hoon and Kim, Jae Hyun and Jeong, Hoseong and Han, Sun-Jin and Kim, Kang Su},
title = {Interlayer Bond Strength of 3D Printed Concrete Members with Ultra High Performance Concrete (UHPC) Mix},
journal = {Buildings},
year = {2024},
volume = {14},
number = {7},
pages = {2060},
doi = {10.3390/buildings14072060}
}
EUVIMED