Development and Characterization of Recyclable Glass Fibers Reinforced Epoxy Composites for Rapid Production via Compression Molding
Polymer Composites · 2026-11-17
DOI: 10.1002/pc.71827 ↗At a glance
Journal article in Polymer Composites, published online on 2026-11-17. Written by Lorena Saitta and 8 co-authors. 83 references.
Abstract (original language)
Glass fibers (GFs)‐reinforced polymer composites combine high mechanical performance with low weight, but their crosslinked epoxy matrices hinder effective end‐of‐life recovery. This study investigates the processing, thermo‐mechanical performance, and chemical recyclability of GFs‐reinforced composites based on the solvolysis‐recyclable EzCiclo RB207‐A/B epoxy system. The neat resin was cured using a conventional long treatment as reference and shortened curing cycles of 8, 10, and 12 min at 150°C, while corresponding laminates were manufactured by compression molding using the three shortened cycles. Differential scanning calorimetry, multi‐frequency dynamic mechanical analysis, flexural testing, and a Design of Experiments approach were used to assess the influence of curing conditions. Experimental properties were also implemented in Ansys Granta Selector and evaluated through Ashby charts. The 8 min cycle produced the least favorable response, whereas the neat resin cured for 12 min showed thermo‐mechanical properties comparable to the reference. For the laminates, the 10 min treatment provided the best overall performance, reaching about 642 MPa flexural strength, 22.5 GPa flexural modulus, and a T g of about 129°C. The laminates were subsequently chemically recycled using SWancor CleaVER reagent, demonstrating the feasibility of rapid manufacturing of mechanically performing and chemically recyclable composites.
Cite
APA
Saitta, L., Evangelista, M., Dattilo, S., Giglio, V., Zinna, L., Barrano, F., Cirrone, G., Simonet, B., & Cicala, G. (2026). Development and Characterization of Recyclable Glass Fibers Reinforced Epoxy Composites for Rapid Production via Compression Molding. Polymer Composites. https://doi.org/10.1002/pc.71827
Vancouver
Saitta L, Evangelista M, Dattilo S, Giglio V, Zinna L, Barrano F, et al. Development and Characterization of Recyclable Glass Fibers Reinforced Epoxy Composites for Rapid Production via Compression Molding. Polymer Composites. 2026. doi:10.1002/pc.71827
BibTeX
@article{Saitta2026,
author = {Saitta, Lorena and Evangelista, Mattia and Dattilo, Sandro and Giglio, Valentina and Zinna, Luca and Barrano, Francesco and Cirrone, Giuseppe and Simonet, Bartolomè and Cicala, Gianluca},
title = {Development and Characterization of Recyclable Glass Fibers Reinforced Epoxy Composites for Rapid Production via Compression Molding},
journal = {Polymer Composites},
year = {2026},
doi = {10.1002/pc.71827}
}
EUVIMED