EUVIMEDAtklāt EUVIMED
Crossref

Optimization Forming Process of CFRP I ‐Shaped Stiffened Panel

Yuan Xie, Yujiao Bai, Meiling Yan, Mingyu Wang, Xin Zhang, Weicheng Nie, Junhang Luo, Wenzhen Qin, Rongguo Wang, Xiaodong He, Guanjun Liu

Polymer Composites · 2026-06-20 · 47 (12) · 11289-11299

DOI: 10.1002/pc.71021 ↗

At a glance

Journal article in Polymer Composites, published online on 2026-03-20. Written by Yuan Xie and 10 co-authors. 39 references. Funded by: Natural Science Foundation of Jiangxi Province, Natural Science Foundation of Shandong Province.

AbstraktsBibliogrāfiskie datiCiteRelated studies

Abstract (original language)

Carbon fiber reinforced polymer (CFRP) stiffened panels are widely used as primary load‐bearing structures due to their high strength‐to‐weight ratio. However, their forming process is susceptible to deformation and defects influenced by factors such as mold material, lay‐up sequence, curing temperature, and heating rate. This study presents a simulation‐based method for optimizing the forming process of CFRP I‐shaped stiffened panels. The numerical model integrates thermochemical analysis with a cure‐hardening instantaneous linear‐elastic model. Optimization of the lay‐up design, including the strategic addition of 0° plies, successfully suppressed torsional deformation in the upper flange and reduced overall panel distortion. The simulations indicate that both curing deformation and residual stress increase with higher curing temperatures and faster heating rates. Numerical and experimental results converged to identify an optimal process utilizing a rubber/stainless steel composite mold, a curing temperature of 393.15 K, and a heating rate of 2 K/min. This optimized setup reduced deformation and residual stress by 23% and 22%, respectively, compared with the baseline aluminum mold process. The proposed strategy significantly enhances the forming accuracy of CFRP stiffened panels and provides.

Funding

  • Natural Science Foundation of Jiangxi Province
  • Natural Science Foundation of Shandong Province

Cite

APA

Xie, Y., Bai, Y., Yan, M., Wang, M., Zhang, X., Nie, W., Luo, J., Qin, W., Wang, R., He, X., & Liu, G. (2026). Optimization Forming Process of CFRP I ‐Shaped Stiffened Panel. Polymer Composites, 47(12), 11289-11299. https://doi.org/10.1002/pc.71021

Vancouver

Xie Y, Bai Y, Yan M, Wang M, Zhang X, Nie W, et al. Optimization Forming Process of CFRP I ‐Shaped Stiffened Panel. Polymer Composites. 2026;47(12):11289-11299. doi:10.1002/pc.71021

BibTeX
@article{Xie2026,
  author = {Xie, Yuan and Bai, Yujiao and Yan, Meiling and Wang, Mingyu and Zhang, Xin and Nie, Weicheng and Luo, Junhang and Qin, Wenzhen and Wang, Rongguo and He, Xiaodong and Liu, Guanjun},
  title = {Optimization Forming Process of CFRP I ‐Shaped Stiffened Panel},
  journal = {Polymer Composites},
  year = {2026},
  volume = {47},
  number = {12},
  pages = {11289--11299},
  doi = {10.1002/pc.71021}
}
Start for free →