Impact of Design Variations and Infill Density in 3D-Printed PLA Components
Polymers · 18.12.2025 · 17 (24) · 3336
DOI: 10.3390/polym17243336 ↗Kurz gefasst
Fachartikel in der Zeitschrift Polymers, online erschienen am 18.12.2025. Verfasst von Pradeep Raja und 3 weiteren Autor:innen. Beteiligte Einrichtung: School of Marine Engineering and Technology, Indian Maritime University, Kolkata Campus, P - 19, Taratalla Road, Kolkata 700 088, India. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 19 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
3D printing offers the ability to fabricate lightweight structural profiles with controlled infill and geometry. This study examines the mechanical behaviour of 3D-printed polylactic acid (PLA) structures with a 10% infill density under four load conditions (10, 15, 20, and 25 N). Four designs (M1, M2, M3, and M4), representing commonly used structural profiles found in beam and column applications, were analysed using ANSYS finite element simulations. Each design was evaluated under roller and nodal boundary conditions to study deformation, stress, and strain responses. Three-point flexural tests were also carried out on all four designs, and the measured peak flexural stress and apparent flexural modulus were compared with the simulated stiffness values. Both the simulations and experimental results showed that Design M3 exhibited the highest stiffness and more consistent behaviour compared to the other designs, while Design M4 showed higher deformation and lower bending resistance. Roller supports generally reduced deformation through better load distribution, whereas nodal supports increased local stiffness in selected designs. Although the magnitude of stiffness differed between simulation and experiment, the ranking of the designs remained consistent. Overall, the study confirms that the geometry plays an important role in their load-bearing performance, and the numerical model provides a reliable tool for comparing and selecting suitable designs before fabrication.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- School of Marine Engineering and Technology, Indian Maritime University, Kolkata Campus, P - 19, Taratalla Road, Kolkata 700 088, India.
- Department of Mechanical Engineering, Rajiv Gandhi Institute of Petroleum Technology, Sivasagar Campus, Assam 785697, India.
- Department of Civil, Environmental and Natural Resources Engineering, Luleå University of Technology, 97187 Luleå, Sweden.
ORCID-Profile: Pradeep Raja, Karthik Babu, Elif Kaynak, Oisik Das
Zitieren
APA
Raja, P., Babu, K., Kaynak, E., & Das, O. (2025). Impact of Design Variations and Infill Density in 3D-Printed PLA Components. Polymers, 17(24), 3336. https://doi.org/10.3390/polym17243336
Vancouver
Raja P, Babu K, Kaynak E, Das O. Impact of Design Variations and Infill Density in 3D-Printed PLA Components. Polymers. 2025;17(24):3336. doi:10.3390/polym17243336
BibTeX
@article{Raja2025,
author = {Raja, Pradeep and Babu, Karthik and Kaynak, Elif and Das, Oisik},
title = {Impact of Design Variations and Infill Density in 3D-Printed PLA Components},
journal = {Polymers},
year = {2025},
volume = {17},
number = {24},
pages = {3336},
doi = {10.3390/polym17243336}
}
EUVIMED