Passive sampler designed for per‐ and polyfluoroalkyl substances using polymer‐modified organosilica adsorbent
AWWA Water Science · 2021-07 · 3 (4)
DOI: 10.1002/aws2.1237 ↗Kurz gefasst
Fachartikel in der Zeitschrift AWWA Water Science, online erschienen am 25.08.2021. Verfasst von Heather Hartmann und 5 weiteren Autor:innen. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: U.S. Department of Defense, Strategic Environmental Research and Development Program.
Abstract (Originalsprache)
A passive sampler designed to measure per‐ and polyfluoroalkyl substances (PFAS) was evaluated to determine chemical uptake rates under a variety of conditions. The sampler design is simple and robust, using organosilica modified with cross‐linked amine polymer in an high density polyethylene housing retained with polypropylene mesh. The addition of amine groups as a weak ion‐exchange resin in combination with Cu 2+ was designed to promote binding of short‐chain PFAS. A five‐fold improvement in perfluorobutanoic acid adsorption was measured when Cu 2+ was added to the polyethylenimine polymer. The samplers showed an integrated response to all analytes tested except for short‐chain PFAS. Sampling rates of PFAS analytes from simulated groundwater were on average 10 mL/day at flow rates of 0.038–1.9 cm/min. Relatively low variability in sampling rate was observed over the range of laboratory tested conditions (representing common conditions in environmental waters) including elevated ionic strength, sulfate concentration, and humic acid content. Article Impact Statement Measuring per‐ and polyfluoroalkyl substances in environmental samples is important for monitoring. Passive samplers can offer practical advantages for making measurements.
Förderung
- U.S. Department of Defense
- Strategic Environmental Research and Development Program
Zitieren
APA
Hartmann, H., Hefner, C., Carter, E., Liles, D., Divine, C., & Edmiston, P. L. (2021). Passive sampler designed for per‐ and polyfluoroalkyl substances using polymer‐modified organosilica adsorbent. AWWA Water Science, 3(4). https://doi.org/10.1002/aws2.1237
Vancouver
Hartmann H, Hefner C, Carter E, Liles D, Divine C, Edmiston PL. Passive sampler designed for per‐ and polyfluoroalkyl substances using polymer‐modified organosilica adsorbent. AWWA Water Science. 2021;3(4). doi:10.1002/aws2.1237
BibTeX
@article{Hartmann2021,
author = {Hartmann, Heather and Hefner, Claire and Carter, Erika and Liles, David and Divine, Craig and Edmiston, Paul L.},
title = {Passive sampler designed for per‐ and polyfluoroalkyl substances using polymer‐modified organosilica adsorbent},
journal = {AWWA Water Science},
year = {2021},
volume = {3},
number = {4},
doi = {10.1002/aws2.1237}
}
EUVIMED