EUVIMEDOpdag EUVIMED
Crossref

Research on Pultrusion Molding of Carbon Fiber Composites Under Vacuum High and Low Temperature Environments

Yonggen Sun, Changxin Du, Cunyi Wang, Peng Li, YeLong Lin, Jiayong Yan, Jinqi Pan, Yun Tian

Journal of Applied Polymer Science · 2026-08-05 · 143 (29)

DOI: 10.1002/app.70855 ↗

At a glance

Journal article in Journal of Applied Polymer Science, published online on 2026-05-14. Written by Yonggen Sun and 7 co-authors. 34 references. Funded by: Natural Science Foundation of Hebei Province.

AbstractBibliografiske oplysningerCiteRelated studies

Abstract (original language)

Fiber‐reinforced thermoplastic composites, with excellent specific strength, specific stiffness, reprocessability and recyclability, are promising for on‐orbit fabrication of large truss structures. In this work, 2 mm‐diameter CF/PEEK rods were fabricated by pultrusion under vacuum with high‐low temperature boundary conditions. The effects of three key processing parameters (ambient temperature: −20°C to 50°C, forming temperature: 370°C to 390°C, pulling speed: 0.25 to 1.00 mm/s) on rod quality, flexural performance and crystallization behavior were systematically investigated. Within the studied parameter window, flexural strength decreased overall with increasing ambient temperature, forming temperature and pulling speed, with maximum reductions of 27.62%, 15.38%, and 27.80%, respectively. DSC results showed that higher crystallinity did not correspond to higher flexural strength. Combined with fracture morphologies, the results indicate that interfacial bonding state and cooling history‐governed shrinkage‐solidification process, rather than crystallinity alone, dominate the mechanical performance. Optimizing processing parameters to regulate cooling rate and improve consolidation in the effective holding zone can enhance rod performance, providing experimental guidance for prospective on‐orbit manufacturing.

Funding

  • Natural Science Foundation of Hebei Province

Cite

APA

Sun, Y., Du, C., Wang, C., Li, P., Lin, Y., Yan, J., Pan, J., & Tian, Y. (2026). Research on Pultrusion Molding of Carbon Fiber Composites Under Vacuum High and Low Temperature Environments. Journal of Applied Polymer Science, 143(29). https://doi.org/10.1002/app.70855

Vancouver

Sun Y, Du C, Wang C, Li P, Lin Y, Yan J, et al. Research on Pultrusion Molding of Carbon Fiber Composites Under Vacuum High and Low Temperature Environments. Journal of Applied Polymer Science. 2026;143(29). doi:10.1002/app.70855

BibTeX
@article{Sun2026,
  author = {Sun, Yonggen and Du, Changxin and Wang, Cunyi and Li, Peng and Lin, YeLong and Yan, Jiayong and Pan, Jinqi and Tian, Yun},
  title = {Research on Pultrusion Molding of Carbon Fiber Composites Under Vacuum High and Low Temperature Environments},
  journal = {Journal of Applied Polymer Science},
  year = {2026},
  volume = {143},
  number = {29},
  doi = {10.1002/app.70855}
}
Start for free →