The Effect of Infill Variation on the Tensile, Bending, Impact, Hardness, and Density Properties of PLA and ABS Materials Produced by FDM
Multidisciplinary Innovations and Research in Applied Engineering · 2025
DOI: 10.70935/1nh12096 ↗Kurz gefasst
Fachartikel in der Zeitschrift Multidisciplinary Innovations and Research in Applied Engineering, 2025. Verfasst von Saeful Rofi Romadhon und 2 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY-NC-SA 4.0).
Abstract (Originalsprache)
Additive Manufacturing (AM) or 3D printing using the Fused Deposition Modelling (FDM) method offers high flexibility in the production of polymer components through process parameter settings, one of which is the infill percentage that affects mechanical performance. This study analyzes the effect of infill variations (25%, 50%, 75%, 100%) on the mechanical properties of two popular thermoplastic materials, Polylactic Acid (PLA) and Acrylonitrile Butadiene Styrene (ABS). Testing was conducted according to ASTM standards, including tensile strength, bending strength, impact strength, hardness, and density. The results show that PLA has higher tensile strength (47–53 MPa), bending strength, and hardness compared to ABS (33–38 MPa). Conversely, ABS demonstrates better toughness through higher impact values, while the difference in density is relatively small and insignificant. Increasing the infill percentage is proven to enhance strength and hardness in both materials, but this is accompanied by an increase in material consumption. These findings indicate a trade-off between stiffness and toughness, so material selection must be tailored to application requirements. PLA is more suitable for precision components requiring dimensional stability, while ABS is recommended for applications with dynamic loads and impact risks. This study provides a practical foundation for optimizing FDM parameters, particularly material and infill, in engineering, medical, and consumer product applications.
Zitieren
APA
Romadhon, S. R., Hidayat, W., & Widagdo, B. S. (2025). The Effect of Infill Variation on the Tensile, Bending, Impact, Hardness, and Density Properties of PLA and ABS Materials Produced by FDM. Multidisciplinary Innovations and Research in Applied Engineering. https://doi.org/10.70935/1nh12096
Vancouver
Romadhon SR, Hidayat W, Widagdo BS. The Effect of Infill Variation on the Tensile, Bending, Impact, Hardness, and Density Properties of PLA and ABS Materials Produced by FDM. Multidisciplinary Innovations and Research in Applied Engineering. 2025. doi:10.70935/1nh12096
BibTeX
@article{Romadhon2025,
author = {Romadhon, Saeful Rofi and Hidayat, Wahyu and Widagdo, Baskara Surya},
title = {The Effect of Infill Variation on the Tensile, Bending, Impact, Hardness, and Density Properties of PLA and ABS Materials Produced by FDM},
journal = {Multidisciplinary Innovations and Research in Applied Engineering},
year = {2025},
doi = {10.70935/1nh12096}
}
EUVIMED