Tribological Performance and Microstructural Characterization of Microwave-Processed Ni-Cr/WC-Co-Cr Composite Cladding on Stainless Steel 304
International Journal of Sciences and Innovation Engineering · 03.08.2026 · 3 (8) · 1-14
DOI: 10.70849/ijsci03082604624 ↗Kurz gefasst
Fachartikel in der Zeitschrift International Journal of Sciences and Innovation Engineering, online erschienen am 03.08.2026. Verfasst von Lovedeep Singh und 1 weiteren Autor:innen.
Abstract (Originalsprache)
Surface degradation caused by wear is one of the major challenges limiting the service life of stainless steel (SS-304) components operating under severe engineering conditions. To overcome this limitation, the present study investigates the development and tribological performance of Ni-Cr reinforced with 20 wt.% WC-Co-Cr composite cladding deposited on SS-304 substrate using the microwave hybrid heating (MHH) technique. Microwave cladding was carried out in a domestic multimode microwave applicator operating at 2.45 GHz with a power rating of 900 W, enabling rapid volumetric heating and strong metallurgical bonding between the clad and substrate. The developed cladding was characterized using scanning electron microscopy (SEM), energy-dispersive spectroscopy (EDS), X-ray diffraction (XRD), and Vickers microhardness testing to evaluate its microstructure, elemental distribution, phase formation, and mechanical properties. The tribological performance was assessed through dry sliding wear tests using a pin-on-disc tribometer following ASTM G99 standards. Microstructural characterization revealed a dense, homogeneous, and defect-minimized clad layer with uniform dispersion of WC-Co-Cr reinforcement within the Ni-Cr matrix. XRD confirmed the presence of hard carbide phases responsible for enhanced mechanical performance. The composite cladding exhibited a significant increase in microhardness, reaching approximately 660 ± 12 HV, compared with 230 ± 10 HV for the SS-304 substrate. Sliding wear results demonstrated substantially lower cumulative weight loss and wear coefficient for the clad specimens, indicating nearly fourfold improvement in wear resistance over the uncoated substrate. SEM analysis of worn surfaces confirmed that the composite cladding effectively minimized severe abrasion, ploughing, and plastic deformation. The study demonstrates that microwave-assisted Ni-Cr/WC-Co-Cr composite cladding is an efficient surface engineering approach for significantly enhancing the tribological performance and service life of SS-304 components intended for demanding industrial applications
Zitieren
APA
Singh, L., & Johal, R. S. (2026). Tribological Performance and Microstructural Characterization of Microwave-Processed Ni-Cr/WC-Co-Cr Composite Cladding on Stainless Steel 304. International Journal of Sciences and Innovation Engineering, 3(8), 1-14. https://doi.org/10.70849/ijsci03082604624
Vancouver
Singh L, Johal RS. Tribological Performance and Microstructural Characterization of Microwave-Processed Ni-Cr/WC-Co-Cr Composite Cladding on Stainless Steel 304. International Journal of Sciences and Innovation Engineering. 2026;3(8):1-14. doi:10.70849/ijsci03082604624
BibTeX
@article{Singh2026,
author = {Singh, Lovedeep and Johal, Ramandeep Singh},
title = {Tribological Performance and Microstructural Characterization of Microwave-Processed Ni-Cr/WC-Co-Cr Composite Cladding on Stainless Steel 304},
journal = {International Journal of Sciences and Innovation Engineering},
year = {2026},
volume = {3},
number = {8},
pages = {1--14},
doi = {10.70849/ijsci03082604624}
}
EUVIMED