Optimization of Additive Manufacturing Parameters for Improved Mechanical Properties of Polymer Components
International Journal on Theoretical and Applied Research in Mechanical Engineering · 2021
DOI: 10.65521/ijtarme.v10i1.4418 ↗Kurz gefasst
Fachartikel in der Zeitschrift International Journal on Theoretical and Applied Research in Mechanical Engineering, 2021. Verfasst von Ixtel Wijesekara.
Abstract (Originalsprache)
Material-extrusion additive manufacturing is increasingly used to produce functional polymer components, but the mechanical performance of printed parts remains strongly dependent on process settings and the layer-wise architecture. This methodology paper develops a compact design-of-experiments framework for optimizing fused deposition modelling/fused filament fabrication (FDM/FFF) parameters for polylactic acid (PLA) components. Four controllable factors—layer thickness, infill density, raster angle and nozzle temperature—are arranged in a Taguchi L9 orthogonal array. Tensile strength and flexural strength are selected as primary responses, with print time retained as a practical secondary response. The proposed workflow combines standardized specimen fabrication, mechanical testing, signal-to-noise analysis, analysis of variance (ANOVA), regression and a confirmation run. Literature up to 2021 shows that lower layer thickness, favorable filament alignment, greater infill and adequate extrusion temperature generally strengthen inter-road and interlayer bonding. To demonstrate the analysis procedure without claiming unperformed laboratory measurements, a literature-bounded numerical dataset is included. The demonstration identifies a low layer thickness, high infill, load-aligned raster and moderate nozzle temperature as the strongest setting, with an estimated tensile-strength improvement of approximately 20% relative to a mid-level baseline. The framework is suitable for later experimental validation and can be extended to ABS, PETG, nylon and reinforced thermoplastics.
Zitieren
APA
Wijesekara, I. (2021). Optimization of Additive Manufacturing Parameters for Improved Mechanical Properties of Polymer Components. International Journal on Theoretical and Applied Research in Mechanical Engineering. https://doi.org/10.65521/ijtarme.v10i1.4418
Vancouver
Wijesekara I. Optimization of Additive Manufacturing Parameters for Improved Mechanical Properties of Polymer Components. International Journal on Theoretical and Applied Research in Mechanical Engineering. 2021. doi:10.65521/ijtarme.v10i1.4418
BibTeX
@article{Wijesekara2021,
author = {Wijesekara, Ixtel},
title = {Optimization of Additive Manufacturing Parameters for Improved Mechanical Properties of Polymer Components},
journal = {International Journal on Theoretical and Applied Research in Mechanical Engineering},
year = {2021},
doi = {10.65521/ijtarme.v10i1.4418}
}
EUVIMED