EUVIMEDSkopri EUVIMED
Crossref

The Optimization of Flow Drilling and Tapping on Thin-Walled Hollow Sections

Mert Şafak Tunalıoğlu

Engineering Perspective · 2026-06-03 · 6 (3) · 446-455

DOI: 10.64808/engineeringperspective.1918985 ↗

At a glance

Journal article in Engineering Perspective, published online on 2026-06-03. Written by Mert Şafak Tunalıoğlu. 30 references.

AstrattDettalji biblijografiċiCiteRelated studies

Abstract (original language)

Drilling and welding operations on thin-walled materials present significant challenges. During drilling, irregularities and cracks often form around the hole, and subsequent tapping results in an insufficient number of threads, leading to easily loosened connections. When additional nuts are welded to strengthen the connection, problems such as material burn-through and deformation can occur. Flowdrill and flowtap methods are used for rapid drilling and screwing of thin-walled holes. Unlike traditional drilling where chips are removed from the workpiece, the flowdrill method displaces the material to form a bushing on the underside. In this study, drilling and threading operations were performed on 1.5 mm AISI 304 stainless steel square and circular profiles using flowdrill and flowtap methods at different rotational speeds, feed rates, and hole diameters. The effects of rotational speed, feed rate, and profile type on bushing height and clamping force were investigated for various hole diameters. Taguchi-Gray Analysis (GRA) method was used to optimize the factors affecting the results and determine their effect ratios. The applicability of the method was examined by comparing the results obtained from the experiments with the Taguchi regression analysis equation and theoretical results. According to the ANOVA results, the largest factor affecting bushing height and clamping force is the spindle speed, with 60-75%. The geometry of the bushes inserted into the material changes with the feed rate. It has been observed that smoother and longer bushings are formed at lower feed rates due to longer friction contact times, while shorter bushings are formed at higher feed rates. The prediction error of the regression models was found to be in the range of 2–4%. This shows the applicability of the equation found.

Cite

APA

Tunalıoğlu, M. Ş. (2026). The Optimization of Flow Drilling and Tapping on Thin-Walled Hollow Sections. Engineering Perspective, 6(3), 446-455. https://doi.org/10.64808/engineeringperspective.1918985

Vancouver

Tunalıoğlu MŞ. The Optimization of Flow Drilling and Tapping on Thin-Walled Hollow Sections. Engineering Perspective. 2026;6(3):446-455. doi:10.64808/engineeringperspective.1918985

BibTeX
@article{Tunalolu2026,
  author = {Tunalıoğlu, Mert Şafak},
  title = {The Optimization of Flow Drilling and Tapping on Thin-Walled Hollow Sections},
  journal = {Engineering Perspective},
  year = {2026},
  volume = {6},
  number = {3},
  pages = {446--455},
  doi = {10.64808/engineeringperspective.1918985}
}
Start for free →