PROGRAMMABLE CONTROLLER AND HUMAN-MACHINE INTERFACE RETROFIT FOR SHEET-METAL CUTTING CONTROL
EDUCATIONE · 09.07.2026 · 731-746
DOI: 10.59397/edu.v4i2.278 ↗Kurz gefasst
Fachartikel in der Zeitschrift EDUCATIONE, online erschienen am 09.07.2026. Verfasst von Rick Resa Wahani und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
A 1995 Colgar sheet-metal cutting machine used in the Manufacturing Laboratory of Politeknik Negeri Manado experienced degraded cutting performance, a disabled automatic cycle, an unreliable safety function, and a non-functional blade-gap adjustment mechanism. This study aimed to retrofit the machine control system by integrating a programmable logic controller, a human-machine interface, limit sensors, a variable-frequency drive, and interlock-based emergency logic. The study used a research-and-development design combined with experimental validation. Data were collected through machine inspection, input-output mapping, ladder-diagram programming, HMI screen development, electrical installation, and functional testing with 2 mm and 6 mm steel plates. The retrofit restored manual and automatic blade movement, reactivated the worktable/blade-gap mechanism, enabled operator monitoring through HMI screens, and improved safety through upper and lower limit sensors, emergency stop logic, visual indicators, and audible alarms. Post-retrofit tests showed that the blade-gap setting operated normally, with a 0.35 mm gap for 2 mm steel plates and a 0.75 mm gap for 6 mm steel plates. The machine could perform a complete automatic down-and-up cycle through a single command while retaining full manual control. The findings indicate that PLC-HMI retrofitting is a practical modernization strategy for legacy sheet-metal machines because it improves functionality, operational accuracy, usability, and machine safety without replacing the main mechanical structure.
Zitieren
APA
Wahani, R. R., Kimbal, M. E. G., Tumembow, M. N., Priyono, & Siwi, H. (2026). PROGRAMMABLE CONTROLLER AND HUMAN-MACHINE INTERFACE RETROFIT FOR SHEET-METAL CUTTING CONTROL. EDUCATIONE, 731-746. https://doi.org/10.59397/edu.v4i2.278
Vancouver
Wahani RR, Kimbal MEG, Tumembow MN, Priyono, Siwi H. PROGRAMMABLE CONTROLLER AND HUMAN-MACHINE INTERFACE RETROFIT FOR SHEET-METAL CUTTING CONTROL. EDUCATIONE. 2026:731-746. doi:10.59397/edu.v4i2.278
BibTeX
@article{Wahani2026,
author = {Wahani, Rick Resa and Kimbal, Michael Edward Gregerio and Tumembow, Moody Noldy and Priyono and Siwi, Herotje},
title = {PROGRAMMABLE CONTROLLER AND HUMAN-MACHINE INTERFACE RETROFIT FOR SHEET-METAL CUTTING CONTROL},
journal = {EDUCATIONE},
year = {2026},
pages = {731--746},
doi = {10.59397/edu.v4i2.278}
}
EUVIMED