EUVIMEDEUVIMED entdecken
Crossref

Correlation between process parameter with surface roughness and weight when producing airfoil of airplane model using 3D printing process

Armansyah Ginting

ARPN Journal of Engineering and Applied Sciences · 20.04.2026 · 239

DOI: 10.59018/022634 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ARPN Journal of Engineering and Applied Sciences, online erschienen am 20.04.2026. Verfasst von Armansyah Ginting. Die Arbeit nennt 22 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study examines the correlation between fused deposition modelling (FDM) process parameters and the surface roughness (Ra) and weight (w) of a 3D-printed NACA 23012 airfoil. Printing speed (v), bed temperature (Tb), layer height (h), and infill density (ρ) were systematically varied using a Taguchi L9 orthogonal array. Nine airfoil specimens were fabricated from PLA+ filament, and surface roughness (Ra) and weight (w) were experimentally measured. Signal-to-noise ratio analysis and analysis of variance revealed that layer height is the dominant factor controlling surface roughness, whereas infill density overwhelmingly governs airfoil weight. Multi-linear regression models were developed and validated through confirmation experiments, enabling quantitative prediction of both response variables within the investigated parameter domain. Unlike conventional FDM optimization studies based on standard test specimens, this work explicitly demonstrates that aerodynamic surface quality (roughness) and structural mass (weight) in true airfoil geometry are governed by distinct parameter hierarchies, allowing their independent optimization. The findings provide experimentally validated guidelines for the additive manufacturing of lightweight and aerodynamically representative airfoil prototypes for rapid prototyping and experimental applications.

Zitieren

APA

Ginting, A. (2026). Correlation between process parameter with surface roughness and weight when producing airfoil of airplane model using 3D printing process. ARPN Journal of Engineering and Applied Sciences, 239. https://doi.org/10.59018/022634

Vancouver

Ginting A. Correlation between process parameter with surface roughness and weight when producing airfoil of airplane model using 3D printing process. ARPN Journal of Engineering and Applied Sciences. 2026:239. doi:10.59018/022634

BibTeX
@article{Ginting2026,
  author = {Ginting, Armansyah},
  title = {Correlation between process parameter with surface roughness and weight when producing airfoil of airplane model using 3D printing process},
  journal = {ARPN Journal of Engineering and Applied Sciences},
  year = {2026},
  pages = {239},
  doi = {10.59018/022634}
}
Kostenlos starten →