EUVIMEDEUVIMED entdecken
Crossref

Chromium Coating of Wollastonite Filled Polyamide 6 and Evaluation of Thermal Cycle Strength

Ramiz AKAY, Hakan YAZICI

Journal of the Turkish Chemical Society Section B: Chemical Engineering · 2023

DOI: 10.58692/jotcsb.1345824 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of the Turkish Chemical Society Section B: Chemical Engineering, 2023. Verfasst von Ramiz AKAY und 1 weiteren Autor:innen. Die Arbeit nennt 15 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The chromium coating of plastic/polymer materials through electrolysis method has attracted attention for improving material properties. The most common material used to be coated is the Acrylonitrile Butadiene Styrene (ABS), but has disadvantages compared to polyamides (PA), such as low thermal resistance. PA’s high water retention disadvantage can be substituted by using fillers such as clay, etc; so in this study, 40% Wollastonite filled PA has been used for chromium plating to increase the thermal resistance of the PA. The plates used were produced by injection molding method. The research is focused on the effect of time and concentration on coating performance in etching, activation (by palladium) and accelerator processes. SEM and EDX were used to characterize samples for surface morphologies and the microstructures of etching, activation and accelerator in the PA sub-plates. Additionally, cross-cut adhesion test has been applied to analyze the adhesion power of the interfaces. It was found that the thermal resistance of the metal plate on the polymer surface decreased as the time increased, in relation with the increasing wearing time of the metal plate mentioned above. The thermal resistance decreased as the polymer deformed in relation with the increase in etching solution’s concentration. It is also seen that the thermal resistance improved as the activation time increased. The adhesion and the thermal resistance did not improve as the time in accelerator process increased. Furthermore, the cross – cut adhesion tests on the same samples concluded that the results are in agreement with the other thermal resistance results.

Zitieren

APA

AKAY, R., & YAZICI, H. (2023). Chromium Coating of Wollastonite Filled Polyamide 6 and Evaluation of Thermal Cycle Strength. Journal of the Turkish Chemical Society Section B: Chemical Engineering. https://doi.org/10.58692/jotcsb.1345824

Vancouver

AKAY R, YAZICI H. Chromium Coating of Wollastonite Filled Polyamide 6 and Evaluation of Thermal Cycle Strength. Journal of the Turkish Chemical Society Section B: Chemical Engineering. 2023. doi:10.58692/jotcsb.1345824

BibTeX
@article{AKAY2023,
  author = {AKAY, Ramiz and YAZICI, Hakan},
  title = {Chromium Coating of Wollastonite Filled Polyamide 6 and Evaluation of Thermal Cycle Strength},
  journal = {Journal of the Turkish Chemical Society Section B: Chemical Engineering},
  year = {2023},
  doi = {10.58692/jotcsb.1345824}
}
Kostenlos starten →