EUVIMEDSkopri EUVIMED
Crossref

Low-profile and flexible printed sensors for Structural Health Monitoring

Marilyne Philibert, Yuhang Pan, Zahra Sharif khodaei, Ferri M.H. Aliabadi

e-Journal of Nondestructive Testing · 2026-08 · 31 (8)

DOI: 10.58286/33768 ↗

At a glance

Journal article in e-Journal of Nondestructive Testing, 2026-08. Written by Marilyne Philibert and 3 co-authors.

AstrattDettalji biblijografiċiCiteRelated studies

Abstract (original language)

A critical challenge in implementing sensors for Structural Health Monitoring (SHM) is minimising the intrusiveness of the sensors and cabling implied. Low-profile and lightweight sensors can be manufactured using printed electronics technologies, which are able to print scalable and flexible devices. By printing the connection wires all-together, heavy extensive cabling is also avoided. This solution would allow integrating larger number of sensors over large area without reducing the mechanical performances of the structure. In this context, printed strain gauges were developed using conductive inks (silver-based and carbon-based) and evaluated as an alternative to conventional strain sensors. The developed silver-based printed sensors were first attached to metal and composite plates using thermoplastic films. Commercially available strain gauges were also attached on the other side of the plates for comparison. Under fatigue testing, the silver-based printed strain gauges showed good sensitivity to strain with resistance change similar to that of commercial strain gauges, despite a very low untrained resistance of 10 Ω. They also showed good repeatability, and fatigue resistance under 1000 cycles of tensile loading. The resulting strain gauges were estimated about 30 times thinner and 30 times cheaper than commercial strain gauges. In addition to improved integration to the structure, using printing technology allows to in-situ fabricate a cheap network of sensors more accurately and more efficiently than manually bonding commercial sensors. To demonstrate adaptability, tailored designs of strain gauges in different directions, i.e. strain rosette, along with connection wires were printed which demonstrated their feasibility to achieve full-field multi-axial strain map. In the attached figure, silver-based printed strain gauges are compared to carbon-based printed strain gauges attached to composite plates. The developed carbon-based printed strain gauges have higher untrained resistance of about 1 kΩ. Under manual bending of the composite plate, they showed considerably higher sensitivity. They were also able to detect strain direction, as the higher strain was for the strain gauge aligned with strain direction, half-strain was detected by the strain gauge at 45°, almost no strain was detected by the strain gauge at 90°. On-going work is further evaluating the monitoring performances of the carbon-based printed strain gauges. These sensors show good potential for embedding within composite structures to create smart structures. The development of other types of printed sensors is also considered to diversify the monitoring performances.

Cite

APA

Philibert, M., Pan, Y., khodaei, Z. S., & Aliabadi, F. M. (2026). Low-profile and flexible printed sensors for Structural Health Monitoring. e-Journal of Nondestructive Testing, 31(8). https://doi.org/10.58286/33768

Vancouver

Philibert M, Pan Y, khodaei ZS, Aliabadi FM. Low-profile and flexible printed sensors for Structural Health Monitoring. e-Journal of Nondestructive Testing. 2026;31(8). doi:10.58286/33768

BibTeX
@article{Philibert2026,
  author = {Philibert, Marilyne and Pan, Yuhang and khodaei, Zahra Sharif and Aliabadi, Ferri M.H.},
  title = {Low-profile and flexible printed sensors for Structural Health Monitoring},
  journal = {e-Journal of Nondestructive Testing},
  year = {2026},
  volume = {31},
  number = {8},
  doi = {10.58286/33768}
}
Start for free →