EUVIMEDSkopri EUVIMED
Crossref

Probabilistic estimation of fatigue damage based on binned data from passive sensors

Mustapha Atmani, André Orcesi, Christophe Biernacki

e-Journal of Nondestructive Testing · 2026-08 · 31 (8)

DOI: 10.58286/33692 ↗

At a glance

Journal article in e-Journal of Nondestructive Testing, 2026-08. Written by Mustapha Atmani and 2 co-authors.

AstrattDettalji biblijografiċiCiteRelated studies

Abstract (original language)

Monitoring bridges under variable traffic loads is essential for safety and predictive maintenance, since cyclic stresses in metallic structures can initiate and propagate cracks, reducing durability. Fatigue is largely driven by stress-amplitude ranges, typically obtained by cycle counting from strain-gauge measurements near structural joints. While strain gauges provide accurate continuous data, they require wiring and power and may suffer from disconnections or measurement bias, which limits their suitability for long-term monitoring. To address these constraints, the SilMach company developed a passive mechanical sensor (ChronoMEMS) that requires no power supply and detects strain amplitudes at the installation location. Unlike active sensors, it outputs aggregated “binned” data: counts of cycles whose amplitudes fall within predefined, often wide, intervals, without recording the full time history. With continuous strain-gauge signals, damage can be computed directly after post-processing (e.g., rainflow counting), whereas binned data require an indirect, probabilistic approach. Stress amplitudes in civil structures are commonly modeled using parametric distributions (e.g., Weibull, log-normal, or mixtures). Once an amplitude distribution is specified, fatigue damage can be expressed through an integral over the density, but it depends on unknown parameters that must be estimated. This study proposes estimating these parameters using an Expectation–Maximization (EM) algorithm adapted to binned data, relying only on interval counts from the passive sensor. A key issue is parameter identifiability, which depends on how much information the binned counts provide relative to the model’s number of parameters. For a two-parameter Weibull model, the three-bin counts from a single ChronoMEMS sensor are sufficient to estimate both parameters. In contrast, for a mixture of two Weibull distributions (five parameters), three counts are generally insufficient, leading to an identifiability problem and motivating either simpler models or additional information. To address this limitation, we assessed damage estimation by approximating a two-Weibull mixture with a single Weibull distribution. The resulting damage estimates are satisfactory on both simulated and real data, except for one simulated scenario in which the two modes of the mixture are widely separated—a configuration that appears unlikely given the available real data but which can not be completely excluded. Handling such cases requires combining two sensors to obtain counts over six intervals. This richer binning enables the estimation of models that are more flexible than a single Weibull distribution while remaining more parsimonious than a full two-Weibull mixture (e.g., an exponential–Weibull mixture, or a Rayleigh–Weibull mixture). Candidate models can then be compared using bayesian information criterion (BIC) to select the best trade-off between goodness of fit and parsimony, thereby reducing the risk of bias due to model misspecification. Finally, after estimating damage, we construct a confidence interval using a bootstrap procedure. This study is part of the SIRCAPASS project (monitoring of road infrastructures using passive sensors), which received financial support from Bpifrance (research call i-Démo, part of the France Relance plan).

Cite

APA

Atmani, M., Orcesi, A., & Biernacki, C. (2026). Probabilistic estimation of fatigue damage based on binned data from passive sensors. e-Journal of Nondestructive Testing, 31(8). https://doi.org/10.58286/33692

Vancouver

Atmani M, Orcesi A, Biernacki C. Probabilistic estimation of fatigue damage based on binned data from passive sensors. e-Journal of Nondestructive Testing. 2026;31(8). doi:10.58286/33692

BibTeX
@article{Atmani2026,
  author = {Atmani, Mustapha and Orcesi, André and Biernacki, Christophe},
  title = {Probabilistic estimation of fatigue damage based on binned data from passive sensors},
  journal = {e-Journal of Nondestructive Testing},
  year = {2026},
  volume = {31},
  number = {8},
  doi = {10.58286/33692}
}
Start for free →