EUVIMEDEUVIMED entdecken
Crossref

Effect of KOH concentration on corrosion behavior and surface morphology of stainless steel 316L for HHO generator application

Basori Basori, Wan M. F. W. Mohamad, Muhd R. Mansor, Noreffendy Tamaldin, Agung Iswandi, Maman K. Ajiriyanto, Ferry Budhi Susetyo

Journal of Electrochemical Science and Engineering · 19.03.2023

DOI: 10.5599/jese.1615 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Electrochemical Science and Engineering, online erschienen am 19.03.2023. Verfasst von Basori Basori und 6 weiteren Autor:innen. Die Arbeit wurde bisher 5-mal zitiert (Crossref). Gefördert von: Universiti Teknikal Malaysia Melaka, Universitas Nasional.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Hydrogen production could be enhanced by increasing the potassium hydroxide (KOH) concentration, but higher KOH concentrations result in higher corrosion rates. Therefore, a deep investigation of the electrochemical behavior of stainless steel (SS 316L) in the KOH solution is needed. This study investigates the influence of KOH concentrations on the electrochemical behavior, surface morphology, structure, and sample phases of SS 316L. The investigations were conducted by some electrochemical techniques, UV-vis, scanning electron microscopy-energy dispersive spectroscopy (SEM-EDS), and X-ray diffraction (XRD). The corrosion rate was found to increase, and solution resistance to decrease with increasing KOH concentration. Samples tested in 5, 30, and 50 g l-1 of KOH showed corrosion rates of 0.457, 2.362, and 5.613 µm year-1, respectively. A wide passive region and the noblest pitting potential were noticed for the sample with 5 g l-1 of KOH. Moreover, Mott-Schottky plots and characteristic wavelengths of UV-Vis suggest the formation of iron and chromium oxides by the passivation of samples. The SEM analysis showed a dynamic change of surface morphology from the lowest to the highest concentration with the intergranular corrosion found at the grain boundaries area. In conclusion, concentrations < 50 g l-1 KOH could be recommended since they would support the optimum remaining life of SS 316 L plates in HHO generators.

Förderung

  • Universiti Teknikal Malaysia Melaka
  • Universitas Nasional

Zitieren

APA

Basori, B., Mohamad, W. M. F. W., Mansor, M. R., Tamaldin, N., Iswandi, A., Ajiriyanto, M. K., & Susetyo, F. B. (2023). Effect of KOH concentration on corrosion behavior and surface morphology of stainless steel 316L for HHO generator application. Journal of Electrochemical Science and Engineering. https://doi.org/10.5599/jese.1615

Vancouver

Basori B, Mohamad WMFW, Mansor MR, Tamaldin N, Iswandi A, Ajiriyanto MK, et al. Effect of KOH concentration on corrosion behavior and surface morphology of stainless steel 316L for HHO generator application. Journal of Electrochemical Science and Engineering. 2023. doi:10.5599/jese.1615

BibTeX
@article{Basori2023,
  author = {Basori, Basori and Mohamad, Wan M. F. W. and Mansor, Muhd R. and Tamaldin, Noreffendy and Iswandi, Agung and Ajiriyanto, Maman K. and Susetyo, Ferry Budhi},
  title = {Effect of KOH concentration on corrosion behavior and surface morphology of stainless steel 316L for HHO generator application},
  journal = {Journal of Electrochemical Science and Engineering},
  year = {2023},
  doi = {10.5599/jese.1615}
}
Kostenlos starten →