Low- and high-viscosity bulk-fill resin composites: a comparison of microhardness, microtensile bond strength, and fracture strength in restored molars
Acta Odontológica Latinoamericana · 2021-09 · 34 (2) · 173-182
DOI: 10.54589/aol.34/2/173 ↗Kurz gefasst
Fachartikel in der Zeitschrift Acta Odontológica Latinoamericana, 2021-09. Verfasst von Fabiana Mg França und 8 weiteren Autor:innen. Beteiligte Einrichtung: Faculdade São Leopoldo Mandic, Instituto de Pesquisas São Leopoldo Mandic, Departamento de Odontologia Restauradora, Campinas, Brasil. biagomes@yahoo…. Hauptthemen laut MEDLINE: Composite Resins, Flexural Strength. Die Arbeit wurde bisher 14-mal zitiert (Crossref). Der Volltext ist frei in PubMed Central verfügbar.
Abstract (Originalsprache)
The aim of this study was to compare low- and high-viscosity bulk-fill composites for Knoop microhardness (KHN), microtensile bond strength (MTBS) to dentin in occlusal cavities, and fracture strength (FS) in molars with mesialocclusal-distal restoration. Disk-shaped samples with different thicknesses (2 or 4 mm) of low-viscosity (SDR Flow, Dentsply) and high-viscosity bulk-fill composites (Filtek BulkFill, 3M ESPE; and Tetric-N Ceram Bulk Fill, Ivoclar Vivadent) were prepared for top and bottom KHN analysis (n=10). MTBS to dentin and fracture pattern was evaluated in human molars with occlusal cavities restored with (n=10): conventional nanocomposite (Z350XT, 3M ESPE), low-viscosity (Filtek Bulk-fill Flow, 3M ESPE) or high-viscosity bulk-fill composites (Filtek BulkFill). The FS and fracture pattern of human molar with mesial-occlusal-distal restorations submitted or not to thermomechanical cycling were investigated (n=10) using: intact tooth (control), and restoration based on conventional microhybrid composite (Z250, 3M ESPE), low-viscosity (SDR Flow) or high-viscosity bulk-fill composites (Filtek BulkFill). The data were submitted to split-plot ANOVA (KHN), one-way ANOVA (MTBS), two-way ANOVA (FS) followed by Tukey’s test (α=0.05). For KHN, there was no significant difference for the resin composites between the top and bottom. For MTBS, no significant differences among the materials were detected; however, the low-viscosity composite presented lower frequency of adhesive failures. For FS, there was no significant difference between composites and intact tooth regardless of thermomechanical cycling. Low- and high-viscosity bulk-fill composites have comparable microhardness and microtensile bond strength when used in occlusal restorations. Likewise, the bulk-fill composites present similar fracture strength in molars with mesio-occlusal-distal restorations.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Faculdade São Leopoldo Mandic, Instituto de Pesquisas São Leopoldo Mandic, Departamento de Odontologia Restauradora, Campinas, Brasil. biagomes@yahoo.com.
- Faculdade São Leopoldo Mandic, Instituto de Pesquisas São Leopoldo Mandic, Departamento de Odontologia Restauradora, Campinas, Brasil.
- University of Florida, Health Faculty Dental Practice, Operative Division, Gainesville, USA.
Zitieren
APA
França, F. M., Tenuti, J. G., Broglio, I. P., Paiva, L. E., Basting, R. T., Turssi, C. P., do Amaral, F. L., Reis, A. F., & Vieira-Junior, W. F. (2021). Low- and high-viscosity bulk-fill resin composites: a comparison of microhardness, microtensile bond strength, and fracture strength in restored molars. Acta Odontológica Latinoamericana, 34(2), 173-182. https://doi.org/10.54589/aol.34/2/173
Vancouver
França FM, Tenuti JG, Broglio IP, Paiva LE, Basting RT, Turssi CP, et al. Low- and high-viscosity bulk-fill resin composites: a comparison of microhardness, microtensile bond strength, and fracture strength in restored molars. Acta Odontológica Latinoamericana. 2021;34(2):173-182. doi:10.54589/aol.34/2/173
BibTeX
@article{Frana2021,
author = {França, Fabiana Mg and Tenuti, Jonathan Gb and Broglio, Isabela P and Paiva, Lara Ej and Basting, Roberta T and Turssi, Cecília P and do Amaral, Flávia Lb and Reis, André F and Vieira-Junior, Waldemir F},
title = {Low- and high-viscosity bulk-fill resin composites: a comparison of microhardness, microtensile bond strength, and fracture strength in restored molars},
journal = {Acta Odontológica Latinoamericana},
year = {2021},
volume = {34},
number = {2},
pages = {173--182},
doi = {10.54589/aol.34/2/173}
}
EUVIMED