EUVIMEDEUVIMED entdecken
Crossref

Experimental Characterization of Conducted EMI in DC/DC Buck Converters: Effects of Duty Cycle and Switching Device

Houcine Miloudi, Abdeslam Lahmani, Sami Bennihi, Mohamed Miloudi, Abdelkader Gourbi, Abdelber Bendaoud

Jordan Journal of Electrical Engineering · 2025 · 11 (4) · 705

DOI: 10.5455/jjee.204-1757601934 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Jordan Journal of Electrical Engineering, 2025. Verfasst von Houcine Miloudi und 5 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The electromagnetic interference (EMI) conducted by a DC/DC buck converter was experimentally investigated in this study. The research focused on the influence of the duty cycle and the selection of switching devices—metal-oxide-semiconductor field-effect transistor (MOSFET) or insulated-gate bipolar transistor (IGBT)—on both common-mode (CM) and differential-mode (DM) emissions. Measurements were conducted in accordance with the EN 55022 conducted emission standard, covering the frequency range from 150 kHz to 30 MHz, using a Line Impedance Stabilization Network (LISN) and a spectrum analyzer. The results reveal that DM emissions dominate the conducted spectrum, exceeding the Class B limit in a narrow frequency band at lower frequencies, while CM emissions generally remain within the limits across most of the measured range. Overall, lower duty cycles lead to higher CM and DM emission levels, whereas higher duty cycles result in a significant reduction in total noise. A comparison of the switching devices shows that the MOSFET-based converter generates more CM noise due to its rapid switching, while the IGBT-based converter maintains lower CM noise but exhibits slightly higher DM emissions under certain conditions. In conclusion, the converter is close to meeting the EN 55022 Class B standard and requires only minor adjustments at low frequencies to achieve full compliance. These findings provide valuable insights into the impact of control parameters and semiconductor selection on conducted EMI, contributing to the design of DC/DC converters that are both efficient and compliant with electromagnetic compatibility (EMC) regulations.

Zitieren

APA

Miloudi, H., Lahmani, A., Bennihi, S., Miloudi, M., Gourbi, A., & Bendaoud, A. (2025). Experimental Characterization of Conducted EMI in DC/DC Buck Converters: Effects of Duty Cycle and Switching Device. Jordan Journal of Electrical Engineering, 11(4), 705. https://doi.org/10.5455/jjee.204-1757601934

Vancouver

Miloudi H, Lahmani A, Bennihi S, Miloudi M, Gourbi A, Bendaoud A. Experimental Characterization of Conducted EMI in DC/DC Buck Converters: Effects of Duty Cycle and Switching Device. Jordan Journal of Electrical Engineering. 2025;11(4):705. doi:10.5455/jjee.204-1757601934

BibTeX
@article{Miloudi2025,
  author = {Miloudi, Houcine and Lahmani, Abdeslam and Bennihi, Sami and Miloudi, Mohamed and Gourbi, Abdelkader and Bendaoud, Abdelber},
  title = {Experimental Characterization of Conducted EMI in DC/DC Buck Converters: Effects of Duty Cycle and Switching Device},
  journal = {Jordan Journal of Electrical Engineering},
  year = {2025},
  volume = {11},
  number = {4},
  pages = {705},
  doi = {10.5455/jjee.204-1757601934}
}
Kostenlos starten →