Effect of Cutting Parameters on Machinability of Titanium Grade 2 during Dry End Milling
International Journal of Experimental Research and Review · 30.04.2026 · 50 · 41-51
DOI: 10.52756/ijerr.2026.v50.003 ↗Kurz gefasst
Fachartikel in der Zeitschrift International Journal of Experimental Research and Review, online erschienen am 30.04.2026. Verfasst von Kirankumar Jagtap und 1 weiteren Autor:innen. Die Arbeit nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Abstract (Originalsprache)
The machining of commercially available titanium grade two in a dry environment using an uncoated solid carbide end mill is evaluated through this research. Using a one-variable-at-a-time (OVAT) method, the independent influences of cutting speed, feed rate, and depth of cut are assessed on the resultant cutting force, surface roughness, and the rate of tool degradation. The variables in this study were set to the ranges 65-105 m/min for cutting speed, 50-250 mm/min for feed rate, and 0.5-2.5 mm for depth of cut. As can be seen from these results, all parameters generally show increased cutting force, surface roughness and tool degradation with higher feed rates and depths of cut; however, the effects of cutting speed are moderate, with surface roughness exhibiting non-linear trends. By comparing the parameters’ influence on the response, the depth of cut was found to be the most dominant factor affecting each machinability response. Next, the feed rate followed by the cutting speed was also shown to have some level of influence. Using the combined response behavior, effective machining ranges were identified to include: 75- 95 m/min cutting speed, 100-200 mm/min feed rate and 0.5-1.5 mm depth of cut. These machining ranges provide consistent levels of cutting forces, surface finishes and tool degradation, making them ideal for use in a variety of machining applications. The information provided within this study provides a good baseline for dry machining of titanium grade two and will be beneficial for use in future multi-parameter optimization studies.
Zitieren
APA
Jagtap, K., & Deshmukh, R. R. (2026). Effect of Cutting Parameters on Machinability of Titanium Grade 2 during Dry End Milling. International Journal of Experimental Research and Review, 50, 41-51. https://doi.org/10.52756/ijerr.2026.v50.003
Vancouver
Jagtap K, Deshmukh RR. Effect of Cutting Parameters on Machinability of Titanium Grade 2 during Dry End Milling. International Journal of Experimental Research and Review. 2026;50:41-51. doi:10.52756/ijerr.2026.v50.003
BibTeX
@article{Jagtap2026,
author = {Jagtap, Kirankumar and Deshmukh, Ravindra R.},
title = {Effect of Cutting Parameters on Machinability of Titanium Grade 2 during Dry End Milling},
journal = {International Journal of Experimental Research and Review},
year = {2026},
volume = {50},
pages = {41--51},
doi = {10.52756/ijerr.2026.v50.003}
}
EUVIMED