EUVIMEDEUVIMED entdecken
Crossref

Material modelling of FDM printed PLA part

Oleg Volgin, Igor Shishkovsky

Engineering Solid Mechanics · 2021 · 153-160

DOI: 10.5267/j.esm.2020.12.004 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Engineering Solid Mechanics, 2021. Verfasst von Oleg Volgin und 1 weiteren Autor:innen. Die Arbeit wurde bisher 18-mal zitiert (Crossref) und nennt 1 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper focuses on modelling inelasticity of additively manufactured polylactide (PLA) thermoplastic using Fused Deposition Modelling (FDM) printing technology. The material response of PLA is viscoplastic and temperature-dependent, as is typically seen for thermoplastics. The inelastic deformation of printed PLA undergoes initial yielding, strain softening, and subsequent failure. The Three-Network (TN) constitutive model was employed in this work, which captures experimentally observed material response and consists of three molecular equilibrium and time-dependent viscous networks that act in parallel. The parameter identification was performed in accordance with experimental data from uniaxial testing and a validation experiment was carried out by loading plate with a hole and measuring its strain distribution using Digital Image Correlation (DIC) method, which was compared with the predictions from Finite Element Analysis (FEA).

Zitieren

APA

Volgin, O., & Shishkovsky, I. (2021). Material modelling of FDM printed PLA part. Engineering Solid Mechanics, 153-160. https://doi.org/10.5267/j.esm.2020.12.004

Vancouver

Volgin O, Shishkovsky I. Material modelling of FDM printed PLA part. Engineering Solid Mechanics. 2021:153-160. doi:10.5267/j.esm.2020.12.004

BibTeX
@article{Volgin2021,
  author = {Volgin, Oleg and Shishkovsky, Igor},
  title = {Material modelling of FDM printed PLA part},
  journal = {Engineering Solid Mechanics},
  year = {2021},
  pages = {153--160},
  doi = {10.5267/j.esm.2020.12.004}
}
Kostenlos starten →