EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Comparison between Marginal Gap of Stone and Metal Dies in a CAD/CAM System

Quasy Abdulateef Hasan, Shahrazad Fouad Karkosh, Raya Hatim Salal, Sandus I. Ibrahim, Zainab Talib Kareem

Dentistry 3000 · 29.05.2026 · 14 (1)

DOI: 10.5195/d3000.2026.1295 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Dentistry 3000, online erschienen am 29.05.2026. Verfasst von Quasy Abdulateef Hasan und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Objective

The purpose of this study was to evaluate and contrast the zirconia crown's marginal gap on stone and metal dies in a CAD/CAM system. Materials and Methods: After preparing a melamine tooth (lower six molar) with 1.5mm occlusal reduction, 1 mm axial reduction and deep shoulder finishing line to construct metal and stone die .It was scanned with a 3D laser scanner by CAD/CAM system. Melamine tooth was milled and replicated into chrome –cobalt die and stone die. Twenty samples as a total, 10 for metal die and 10 for stone die were prepared. On the master die, marginal gaps were measured at four specific locations on each surface (mesial, buccal, distal, and lingual). Using a microscope digital camera (Dino Lite) at a magnification of 110X, the direct view technique was employed, and the measurements of the marginal gap were recorded using the image J software.

Results

In the metal group the highest marginal gap was recorded while the lowest marginal gap was recorded with the stone group.

Conclusion

The metal group recorded a statistically significant higher marginal gap than the marginal gap that was recorded in the stone group. Stone die was more accurate when 3D scanner is used.

Zitieren

APA

Hasan, Q. A., Karkosh, S. F., Salal, R. H., Ibrahim, S. I., & Kareem, Z. T. (2026). Comparison between Marginal Gap of Stone and Metal Dies in a CAD/CAM System. Dentistry 3000, 14(1). https://doi.org/10.5195/d3000.2026.1295

Vancouver

Hasan QA, Karkosh SF, Salal RH, Ibrahim SI, Kareem ZT. Comparison between Marginal Gap of Stone and Metal Dies in a CAD/CAM System. Dentistry 3000. 2026;14(1). doi:10.5195/d3000.2026.1295

BibTeX
@article{Hasan2026,
  author = {Hasan, Quasy Abdulateef and Karkosh, Shahrazad Fouad and Salal, Raya Hatim and Ibrahim, Sandus I. and Kareem, Zainab Talib},
  title = {Comparison between Marginal Gap of Stone and Metal Dies in a CAD/CAM System},
  journal = {Dentistry 3000},
  year = {2026},
  volume = {14},
  number = {1},
  doi = {10.5195/d3000.2026.1295}
}
Kostenlos starten →