EUVIMEDEUVIMED entdecken
Crossref

Effect of onlay material and preparation design on fatigue behavior and stress distribution in molars: 3D-FEA

Ayham Darwich, Abeer Aljareh, Chaza Kanout, Hasan Nazha

Journal of Stomatology · 2023 · 76 (1) · 43-53

DOI: 10.5114/jos.2022.123331 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Stomatology, 2023. Verfasst von Ayham Darwich und 3 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Introduction

Onlays are conservative restorations for posterior teeth that cover one cusp or more.

Objectives

The aim of this study was to evaluate fatigue behavior and stress distribution in mandibular molars with different onlays and preparation designs under static and cyclic conditions, using finite element analysis.Material and methods: A model of a mandibular molar was obtained from a CBCT image.Mesio-occluso-distal cavities were presented with conservative and extensive buccolingual widths of the occlusal cavity.Buccal and lingual cusps were reduced.Therefore, onlays that covered buccal cusps and onlays that covered all cusps designs were obtained.All onlays were produced from three materials: lithium disilicate ceramic (LDS), polymer-infiltrated ceramic network (PICN), and zirconia ceramic.Safety factor was calculated and stress distribution was analyzed according to von Mises and maximum principal stress theories under static and cyclic conditions.

Results

Cyclic loading caused higher stresses than static loading.The safety factor of zirconia and LDS onlays was higher than 1, except for conservative preparation with all-cusp coverage.PICN showed the lowest values of safety factors and the highest stress concentration in the dental tissues, which was associated with the least stresses in onlays.LDS and zirconia ceramic onlays showed lower stress concentration in dental structures than PICN.

Conclusions

Loading conditions affected the results of stress in all models.Zirconia ceramic could be a suitable choice to restore mandibular molars, while PICN onlay might be an inappropriate restoration in terms of safety factors and stress distribution in restored dental structures.

Zitieren

APA

Darwich, A., Aljareh, A., Kanout, C., & Nazha, H. (2023). Effect of onlay material and preparation design on fatigue behavior and stress distribution in molars: 3D-FEA. Journal of Stomatology, 76(1), 43-53. https://doi.org/10.5114/jos.2022.123331

Vancouver

Darwich A, Aljareh A, Kanout C, Nazha H. Effect of onlay material and preparation design on fatigue behavior and stress distribution in molars: 3D-FEA. Journal of Stomatology. 2023;76(1):43-53. doi:10.5114/jos.2022.123331

BibTeX
@article{Darwich2023,
  author = {Darwich, Ayham and Aljareh, Abeer and Kanout, Chaza and Nazha, Hasan},
  title = {Effect of onlay material and preparation design on fatigue behavior and stress distribution in molars: 3D-FEA},
  journal = {Journal of Stomatology},
  year = {2023},
  volume = {76},
  number = {1},
  pages = {43--53},
  doi = {10.5114/jos.2022.123331}
}
Kostenlos starten →