EUVIMEDEUVIMED entdecken
Crossref

Evaluation of some mechanical and physical properties of different types of injectable polymer materials used as a base for removable orthodontic appliances

Alaa Albo Hassan, Ali Jameel, Mohammed Nahidh, Dina Hamid

Journal of Stomatology · 2019 · 72 (5) · 215-221

DOI: 10.5114/jos.2019.93297 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Stomatology, 2019. Verfasst von Alaa Albo Hassan und 3 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Introduction

For many years, cold cure acrylic has been used to construct the removable orthodontic appliances that treated simple cases.The main problem with this type of acrylic is related to monomer release unlike the heat cure acrylic type.With the advances in materials, new injectable polymer materials were developed for construction of removable and complete dentures, but no study has been performed to compare their properties with Orthocryl used for removable orthodontic appliance construction.

Objectives

Aim of the study was to evaluate some mechanical and physical properties of two new materials for use in denture base construction in comparison with Orthocryl.Material and methods: A total of 150 specimens, 50 each of self-cure acrylic (Orthocryl), polycarbonate (M10) and injectable acrylic (Acrilato), were fabricated according to the manufacturers' instructions.The following properties were tested using 10 samples of each type: impact strength, hardness, surface roughness, flexural strength, and water sorption and solubility.One-way ANOVA followed by post-hoc Tukey tests compared results among the groups.

Results

Statistically significant group differences were found in all tests except those for water sorption and solubility, which showed non-significant differences.

Conclusions

The good properties of M10 and Acrilato make them suitable alternatives to Orthocryl.The major issue is the cost and the availability of the required softening device in dental laboratories.

Zitieren

APA

Hassan, A. A., Jameel, A., Nahidh, M., & Hamid, D. (2019). Evaluation of some mechanical and physical properties of different types of injectable polymer materials used as a base for removable orthodontic appliances. Journal of Stomatology, 72(5), 215-221. https://doi.org/10.5114/jos.2019.93297

Vancouver

Hassan AA, Jameel A, Nahidh M, Hamid D. Evaluation of some mechanical and physical properties of different types of injectable polymer materials used as a base for removable orthodontic appliances. Journal of Stomatology. 2019;72(5):215-221. doi:10.5114/jos.2019.93297

BibTeX
@article{Hassan2019,
  author = {Hassan, Alaa Albo and Jameel, Ali and Nahidh, Mohammed and Hamid, Dina},
  title = {Evaluation of some mechanical and physical properties of different types of injectable polymer materials used as a base for removable orthodontic appliances},
  journal = {Journal of Stomatology},
  year = {2019},
  volume = {72},
  number = {5},
  pages = {215--221},
  doi = {10.5114/jos.2019.93297}
}
Kostenlos starten →