EUVIMEDScopri EUVIMED
Crossref

Metallurgical Approach to In Situ Reverse Sensitization of Al-Mg Naval Alloy

Myrto K. Galoni, George Gougoulidis, Spyros Papaefthymiou

Corrosion · 2026-06-01 · 82 (6) · 482-495

DOI: 10.5006/4873 ↗

At a glance

Journal article in Corrosion, published online on 2026-03-31. Written by Myrto K. Galoni and 2 co-authors. 27 references.

AbstractDati bibliograficiCiteRelated studies

Abstract (original language)

This work focuses on the development of an in situ sensitization remediation heat treatment in Al-Mg alloy structural components retrieved from operating vessels, with emphasis on the influence of microstructure, residual stresses, and operational history on the desensitization kinetics. Optimal conditions vary based on the above-mentioned parameters for different vessels. Optimum conditions were identified as 280°C for 2 h for vessel I and 320°C for 2 h for vessel II in the laboratory scale. The degree of sensitization (DOS) was able to be reduced from 54 mg/cm2 to 61 mg/cm2 and 97.60 mg/cm2 to below 10 mg/cm2. The minimum time required to achieve a measurable DOS reduction was 40 min for vessel I (partial mitigation), while achieving DOS lower than 20 mg/cm2 required at least 70 min for laboratory scale samples; however, in the case of vessel II, 2 h was the minimum time required. The experimental results demonstrated that indeed the initial microstructure, the microstrain state, and the operational history critically influence the response of the remediation treatment. Metallography revealed disruption and coarsening of the intergranular β phase network with minimal grain growth consistent with diffusion-controlled transformation. Discontinuous precipitation reaction was detected in an intermediately sensitized specimen remediated to 21 mg/cm2, representing the first such observation in the Al-Mg system. It is stressed that large specimens from real vessels and not tiny lab-scale specimens that are usually tested require considerably longer treatments, confirming that effective remediation demands tailored treatment conditions based on the individual structural and service characteristics.

Cite

APA

Galoni, M. K., Gougoulidis, G., & Papaefthymiou, S. (2026). Metallurgical Approach to In Situ Reverse Sensitization of Al-Mg Naval Alloy. Corrosion, 82(6), 482-495. https://doi.org/10.5006/4873

Vancouver

Galoni MK, Gougoulidis G, Papaefthymiou S. Metallurgical Approach to In Situ Reverse Sensitization of Al-Mg Naval Alloy. Corrosion. 2026;82(6):482-495. doi:10.5006/4873

BibTeX
@article{Galoni2026,
  author = {Galoni, Myrto K. and Gougoulidis, George and Papaefthymiou, Spyros},
  title = {Metallurgical Approach to In Situ Reverse Sensitization of Al-Mg Naval Alloy},
  journal = {Corrosion},
  year = {2026},
  volume = {82},
  number = {6},
  pages = {482--495},
  doi = {10.5006/4873}
}
Start for free →