EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Process Parameter Optimization in Finish Wire Electrical Discharge Machining of SUS420J2 Steel

Nguyen Trong Mai, Du Thi Kieu Trinh, Nguyen Viet Hung

Engineering, Technology & Applied Science Research · 04.04.2026 · 16 (2) · 33479-33484

DOI: 10.48084/etasr.17405 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Engineering, Technology & Applied Science Research, online erschienen am 04.04.2026. Verfasst von Nguyen Trong Mai und 2 weiteren Autor:innen. Die Arbeit nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Wire Electrical Discharge Machining (WEDM) is a non-traditional manufacturing technique widely used in many industrial sectors. This study aims to identify the optimal settings for three key process parameters in the finishing process of SUS420J2 steel. A 15-trial experimental matrix was established using the Box-Behnken design and incorporating input variables such as peak current, voltage, and pulse-on time. Two output responses were evaluated for each trial: surface roughness and white layer thickness, applying a novel computational framework, Method based on the Removal Effects of Criteria - Rank Order Centroid (MEREC-ROC), to determine the relative importance. The Generalized Reduced Gradient (GRG) algorithm was applied to address the multi-objective optimization challenge, with peak current, voltage, and pulse-on time being measured at 1.94 A, 79.6 V, and 6.96 μs, respectively. Under these conditions, surface roughness and white layer thickness simultaneously reached their minimum levels, at 1.262 μm and 4.828 μm, respectively. Furthermore, this study analyzes in depth the degree to which each process parameter influences the resulting responses.

Zitieren

APA

Mai, N. T., Trinh, D. T. K., & Hung, N. V. (2026). Process Parameter Optimization in Finish Wire Electrical Discharge Machining of SUS420J2 Steel. Engineering, Technology & Applied Science Research, 16(2), 33479-33484. https://doi.org/10.48084/etasr.17405

Vancouver

Mai NT, Trinh DTK, Hung NV. Process Parameter Optimization in Finish Wire Electrical Discharge Machining of SUS420J2 Steel. Engineering, Technology & Applied Science Research. 2026;16(2):33479-33484. doi:10.48084/etasr.17405

BibTeX
@article{Mai2026,
  author = {Mai, Nguyen Trong and Trinh, Du Thi Kieu and Hung, Nguyen Viet},
  title = {Process Parameter Optimization in Finish Wire Electrical Discharge Machining of SUS420J2 Steel},
  journal = {Engineering, Technology & Applied Science Research},
  year = {2026},
  volume = {16},
  number = {2},
  pages = {33479--33484},
  doi = {10.48084/etasr.17405}
}
Kostenlos starten →