EUVIMEDEUVIMED entdecken
Crossref

Influence of Raw Material Size on the Microstructure of Graphene Oxide and Its Early Strengthening Properties of Cemen

TONG Yu, CUI Yahe, DING Xiangqun, ZHAO Mingyu

Progress in Chinese Materials Sciences · 2023

DOI: 10.48014/pcms.20230424001 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Progress in Chinese Materials Sciences, 2023. Verfasst von TONG Yu und 3 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

With the purpose of exploring the influence of raw material size on the structure-performance of graphene oxide (GO) for cement reinforcement, this paper used natural flaked graphite with different particle sizes as raw material to prepare GO nanosheets by a method of enhanced Hummers, and then used scanning electron microscope (SEM) , X-ray diffraction (XRD) , Raman spectrum, infrared spectrum (IR) and other means to characterise the microstructure of GO products in detail, and then investigated the effects of raw material size and graphene oxide GO dosage on its early strengthening effect in cement. The experimental results showed that with the decrease of raw material particle size, the spacing between the layers of GO products is basically the same, while the oxidization degree is increased, and the oxygen-containing groups on the surface are increased. When the GO matt was used to prepare cement mortar with same GO extent, the mechanical strengths at an age of 3 days were found to initially increase and then decrease with the reduction of raw material particle size, and the GO products had the best effect on the improvement of early mechanical strength of cement when the raw material particle size was 13μm. On the other hand, GO matt being obtained from the raw material particles in a size of 13μm was employed to prepare cement mortar with different GO content, of which the 3d strength was found to increase apparently with the increasing GO content, and thus resulted in the increment of 8. 85% to the 3d compressive strength and 6. 34% to the 3d flexural strength for the mortar specimen obtained with a GO content of about 0. 05%, but the further increasing of the GO content is not proposed, which might gave rise of a relative low mechanical strength.

Zitieren

APA

Yu, T., Yahe, C., Xiangqun, D., & Mingyu, Z. (2023). Influence of Raw Material Size on the Microstructure of Graphene Oxide and Its Early Strengthening Properties of Cemen. Progress in Chinese Materials Sciences. https://doi.org/10.48014/pcms.20230424001

Vancouver

Yu T, Yahe C, Xiangqun D, Mingyu Z. Influence of Raw Material Size on the Microstructure of Graphene Oxide and Its Early Strengthening Properties of Cemen. Progress in Chinese Materials Sciences. 2023. doi:10.48014/pcms.20230424001

BibTeX
@article{Yu2023,
  author = {Yu, TONG and Yahe, CUI and Xiangqun, DING and Mingyu, ZHAO},
  title = {Influence of Raw Material Size on the Microstructure of Graphene Oxide and Its Early Strengthening Properties of Cemen},
  journal = {Progress in Chinese Materials Sciences},
  year = {2023},
  doi = {10.48014/pcms.20230424001}
}
Kostenlos starten →