EUVIMEDEUVIMED entdecken
Crossref

Optimisation of tensile stress of poly(lactic acid) 3D printed materials using response surface methodology

Miloš Vorkapić, Ivana Mladenović, Marija Pergal, Toni Ivanov, Marija Baltić

Tribology and Materials · 2022

DOI: 10.46793/tribomat.2022.009 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Tribology and Materials, 2022. Verfasst von Miloš Vorkapić und 4 weiteren Autor:innen. Die Arbeit wurde bisher 8-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Three-dimensional printed plastic products developed through fused deposition modelling (FDM) take long-term mechanical loading in most industrial prototypes. This article focuses on the impact of the 3D printing parameters, type of thermal treatment and variation of characteristic dimensions of standard specimens on the tensile properties of poly(lactic acid) (PLA) material. Two mediums were used for thermal treatment: NaCl powder and plaster. The specimens immersed in NaCl powder were heated to the melting temperature of the filament (200 °C), while the processing of the plastered specimens was performed at a temperature of 100 °C. After treatment, the specimens were cooled at room temperature (25 °C), and the dimensions of the annealed and untreated specimens were controlled. The tensile test of the specimens was performed on the universal test machine. The response surface methodology (RSM) is employed to predict the tensile stress by undertaking input parameters. The analysis of variance (ANOVA) results revealed that the untreated specimens, orientation –45/45 and layer thickness of 0.1 mm had the highest tensile stress value. Thermal treatment in plaster showed a significant increase in tensile strength, while the best specimens were obtained after treatment in NaCl, and all refer to the –45/45 (0.1 mm) orientation.

Zitieren

APA

Vorkapić, M., Mladenović, I., Pergal, M., Ivanov, T., & Baltić, M. (2022). Optimisation of tensile stress of poly(lactic acid) 3D printed materials using response surface methodology. Tribology and Materials. https://doi.org/10.46793/tribomat.2022.009

Vancouver

Vorkapić M, Mladenović I, Pergal M, Ivanov T, Baltić M. Optimisation of tensile stress of poly(lactic acid) 3D printed materials using response surface methodology. Tribology and Materials. 2022. doi:10.46793/tribomat.2022.009

BibTeX
@article{Vorkapi2022,
  author = {Vorkapić, Miloš and Mladenović, Ivana and Pergal, Marija and Ivanov, Toni and Baltić, Marija},
  title = {Optimisation of tensile stress of poly(lactic acid) 3D printed materials using response surface methodology},
  journal = {Tribology and Materials},
  year = {2022},
  doi = {10.46793/tribomat.2022.009}
}
Kostenlos starten →