EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Trends in Materials Modeling and Computation for Metal Additive Manufacturing

Seoyeon Jeon, Hyunjoo Choi

journal of Korean Powder Metallurgy Institute · 2024

DOI: 10.4150/jpm.2024.00150 ↗

Kurz gefasst

Fachartikel in der Zeitschrift journal of Korean Powder Metallurgy Institute, 2024. Verfasst von Seoyeon Jeon und 1 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 41 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: National Research Foundation of Korea.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Additive Manufacturing (AM) is a process that fabricates products by manufacturing materials according to a three-dimensional model. It has recently gained attention due to its environmental advantages, including reduced energy consumption and high material utilization rates. However, controlling defects such as melting issues and residual stress, which can occur during metal additive manufacturing, poses a challenge. The trial-and-error verification of these defects is both time-consuming and costly.Consequently, efforts have been made to develop phenomenological models that understand the influence of process variables on defects, and mechanical/electrical/thermal properties of geometrically complex products. This paper introduces modeling techniques that can simulate the powder additive manufacturing process. The focus is on representative metal additive manufacturing processes such as Powder Bed Fusion (PBF), Direct Energy Deposition (DED), and Binder Jetting (BJ) method.To calculate thermal-stress history and the resulting deformations, modeling techniques based on Finite Element Method (FEM) are generally utilized. For simulating the movements and packing behavior of powders during powder classification, modeling techniques based on Discrete Element Method (DEM) are employed. Additionally, to simulate sintering and microstructural changes, techniques such as Monte Carlo (MC), Molecular Dynamics (MD), and Phase Field Modeling (PFM) are predominantly used.

Förderung

  • National Research Foundation of Korea

Zitieren

APA

Jeon, S., & Choi, H. (2024). Trends in Materials Modeling and Computation for Metal Additive Manufacturing. journal of Korean Powder Metallurgy Institute. https://doi.org/10.4150/jpm.2024.00150

Vancouver

Jeon S, Choi H. Trends in Materials Modeling and Computation for Metal Additive Manufacturing. journal of Korean Powder Metallurgy Institute. 2024. doi:10.4150/jpm.2024.00150

BibTeX
@article{Jeon2024,
  author = {Jeon, Seoyeon and Choi, Hyunjoo},
  title = {Trends in Materials Modeling and Computation for Metal Additive Manufacturing},
  journal = {journal of Korean Powder Metallurgy Institute},
  year = {2024},
  doi = {10.4150/jpm.2024.00150}
}
Kostenlos starten →