EUVIMEDEUVIMED entdecken
Crossref

The Effect of Ni Content in Electroless Cu Deposit on the Adhesion Between the Seed Layer and Glass Substrate

Kanji Matsumoto, Tomoharu Nakayama, Shinichiro Yoshida, Hisamitsu Yamamoto

IMAPSource Proceedings · 27.10.2026 · 2026 (Symposium)

DOI: 10.4071/001c.173305 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IMAPSource Proceedings, online erschienen am 27.10.2026. Verfasst von Kanji Matsumoto und 3 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this paper, we discuss a method of improving the adhesion of the seed layer, consisting of a metal oxide deposit and electroless copper film, on the glass substrate. The rapid development of AI technology has dramatically increased the demand for High-Performance Computing (HPC), which requires the processing of massive datasets at extremely high speeds. To achieve high-performance processing for use in HPC, more chiplets should be mounted on a single substrate. As a result, the substrate must satisfy several requirements, such as finer lines and spaces, improved high-frequency performance, larger substrate sizes, and high reliability. However, conventional organic substrates often fall short due to issues such as substrate warpage and high insertion loss at high frequency, caused by their properties. Glass has emerged as a promising alternative to resolve these problems because of its advantageous properties: high stiffness, surface smoothness, low coefficient of thermal expansion (CTE) and low dielectric loss (Df). Consequently, there have been numerous efforts to develop new manufacturing processes for glass core substrates. Although the glass is considered a suitable core material, one of the main challenges is achieving good adhesion between the copper film and the glass substrate when using copper for circuit formation. For this reason, in this study, we investigated the process for forming seed layers on glass with enhanced adhesion. In the Semi-Additive process (SAP), which is commonly used in substrate fabrication, plating core materials with electroless copper plating before electrolytic copper plating deposition is common. However, we introduced Metal Oxide Seed Layer (MOSL) with approximately 0.2 μm thickness between the glass and the plating layer in this research. This approach enables the formation of a seed layer with superior adhesion to glass. We evaluated the adhesion by measuring the peel strength. Our results show that increasing Ni concentration in the electroless copper bath improved the deposit’s adhesion to the glass. The best result was achieved with a deposit composed of Glass / MOSL / Cu-Ni alloy (4.6 at% Ni), which exhibited a peel strength of 1000 gf/cm. The value was around two times higher than that of MOSL / Cu-Ni alloy film with 1.4 at% Ni. These results indicate that the increasing amount of co-deposited Ni in the Cu deposit greatly enhances the adhesion. To investigate the mechanism behind this improvement, we performed STEM-EDX analysis to examine the deposit composition. In as-plated samples, no Cu was detected at the interface between the glass and MOSL, regardless of Ni content. However, in post-annealed samples with 1.4 at% Ni, a small amount of Cu was observed at the interface, whereas in the 4.6 at% Ni samples, Cu was barely detectable in that region. These results suggest that high-Ni-content Cu alloy deposits act as a self-formed barrier layer, preventing Cu diffusion through the MOSL layer—a phenomenon well known in sputtering studies. This barrier effect contributes significantly to the improved adhesion between the seed layer and the glass. Our method is expected to enable the formation of high-coverage seed layers inside Through-Glass Vias (TGVs) with high aspect ratios (AR: 10–20), paving the way for advanced glass-based substrates in high-performance applications.

Zitieren

APA

Matsumoto, K., Nakayama, T., Yoshida, S., & Yamamoto, H. (2026). The Effect of Ni Content in Electroless Cu Deposit on the Adhesion Between the Seed Layer and Glass Substrate. IMAPSource Proceedings, 2026(Symposium). https://doi.org/10.4071/001c.173305

Vancouver

Matsumoto K, Nakayama T, Yoshida S, Yamamoto H. The Effect of Ni Content in Electroless Cu Deposit on the Adhesion Between the Seed Layer and Glass Substrate. IMAPSource Proceedings. 2026;2026(Symposium). doi:10.4071/001c.173305

BibTeX
@article{Matsumoto2026,
  author = {Matsumoto, Kanji and Nakayama, Tomoharu and Yoshida, Shinichiro and Yamamoto, Hisamitsu},
  title = {The Effect of Ni Content in Electroless Cu Deposit on the Adhesion Between the Seed Layer and Glass Substrate},
  journal = {IMAPSource Proceedings},
  year = {2026},
  volume = {2026},
  number = {Symposium},
  doi = {10.4071/001c.173305}
}
Kostenlos starten →