Investigations into electroless copper seed layer deposition in through-glass vias based 3D packaging
Journal of Micromechanics and Microengineering · 01.05.2026 · 36 (5) · 055005
DOI: 10.1088/1361-6439/ae670d ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Micromechanics and Microengineering, online erschienen am 15.05.2026. Verfasst von Karan Pawar und 1 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 39 Literaturangaben.
Abstract (Originalsprache)
Electroless copper seed layer uniformity is a critical requirement for reliable through-glass via (TGV) metallization. In this work, electroless Cu deposition in tapered vias with an aspect ratio of ∼4 is investigated using a combined numerical and experimental approach. A two-dimensional axisymmetric finite-element model incorporating species diffusion, surface reaction kinetics, and moving-boundary mesh deformation was used to simulate Cu thickness evolution along via sidewalls during electroless deposition at 30 °C for 1200 s. The simulated Cu thickness varies from ∼450 nm near the via entrance and exit regions to ∼250 nm at intermediate depths. Cross-sectional scanning electron microscopy analysis of electroless Cu deposited in silicon through-holes processed under identical conditions shows corresponding thickness values of ∼400 nm near the top and bottom regions and ∼200 nm at the mid-depth. Electroless Cu films deposited for 20 min exhibit continuous coverage with a sheet resistance of ∼0.24 Ω/□, a peel adhesion strength of ∼2.65 N cm −1 , and a tensile residual stress of ∼33.5 MPa for an average thickness of ∼200 nm. Electrical continuity of glass-based redistribution lines (RDL) test vehicles was shown by fabricating a test vehicle using electroless Cu followed by Cu electrodeposition. A linear current-voltage behavior across the TGV-RDL network was demonstrated with measured electrical resistance of ∼1.09 Ω.
Zitieren
APA
Pawar, K., & Dixit, P. (2026). Investigations into electroless copper seed layer deposition in through-glass vias based 3D packaging. Journal of Micromechanics and Microengineering, 36(5), 055005. https://doi.org/10.1088/1361-6439/ae670d
Vancouver
Pawar K, Dixit P. Investigations into electroless copper seed layer deposition in through-glass vias based 3D packaging. Journal of Micromechanics and Microengineering. 2026;36(5):055005. doi:10.1088/1361-6439/ae670d
BibTeX
@article{Pawar2026,
author = {Pawar, Karan and Dixit, Pradeep},
title = {Investigations into electroless copper seed layer deposition in through-glass vias based 3D packaging},
journal = {Journal of Micromechanics and Microengineering},
year = {2026},
volume = {36},
number = {5},
pages = {055005},
doi = {10.1088/1361-6439/ae670d}
}
EUVIMED