Comparative Study on Grinding Behavior of C-Face and Si-Face in Laser-Sliced 4H-SiC Wafers
Materials Science Forum · 21.05.2026 · 1193 · 1-7
DOI: 10.4028/p-xc7fbw ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials Science Forum, online erschienen am 21.05.2026. Verfasst von Bi Xue Li und 8 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 13 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
With the growing application of wide-bandgap semiconductors such as SiC in power electronics, efficient and low-damage machining of large-diameter, high-quality 4H-SiC wafers has become a critical research priority. This study systematically compares the grinding behavior of the C-and Si-faces of laser-sliced 4H-SiC wafers and reveals the effect of crystallographic anisotropy on tool wear. In the experiments, a picosecond laser was used to induce internal crystal modification, and multiple pairs of 12-inch high-purity semi-insulating crystals and wafers were obtained through ultrasonic separation. These wafers were subsequently ground using #800/#8000 resin-bonded diamond wheels. Material removal and wheel wear were recorded in real time, and the wheel wear ratio (W/M) was adopted as the key evaluation metric. Nanoindentation and white-light interferometry were further employed to characterize the mechanical properties and surface morphology of the two crystal faces. Results show that in both rough and fine grinding, the C-face demonstrates superior material removal performance despite its higher hardness, whereas the Si-face is more prone to wheel degradation. For thin wafers, residual laser focus near the surface further aggravates wheel wear. These findings establish a link between crystallographic anisotropy, laser-modified layer position, and wheel wear behavior, providing an experimental foundation for clarifying the underlying mechanisms and developing face-specific grinding strategies for high-quality SiC wafer fabrication.
Zitieren
APA
Li, B. X., Zhang, X., Chen, Q., Che, L. L., Zhang, J. F., Fan, H. Y., Xu, X. G., Wang, R. K., & Chen, X. F. (2026). Comparative Study on Grinding Behavior of C-Face and Si-Face in Laser-Sliced 4H-SiC Wafers. Materials Science Forum, 1193, 1-7. https://doi.org/10.4028/p-xc7fbw
Vancouver
Li BX, Zhang X, Chen Q, Che LL, Zhang JF, Fan HY, et al. Comparative Study on Grinding Behavior of C-Face and Si-Face in Laser-Sliced 4H-SiC Wafers. Materials Science Forum. 2026;1193:1-7. doi:10.4028/p-xc7fbw
BibTeX
@article{Li2026,
author = {Li, Bi Xue and Zhang, Xing and Chen, Qiu and Che, Lin Lin and Zhang, Jian Fei and Fan, Hao Yu and Xu, Xian Gang and Wang, Rong Kun and Chen, Xiu Fang},
title = {Comparative Study on Grinding Behavior of C-Face and Si-Face in Laser-Sliced 4H-SiC Wafers},
journal = {Materials Science Forum},
year = {2026},
volume = {1193},
pages = {1--7},
doi = {10.4028/p-xc7fbw}
}
EUVIMED