EUVIMEDEUVIMED entdecken
Crossref

Modeling and Investigation of 3D Printing Parameters on the Melt Flow Behavior of Polylactic Acid

Peeraphat Suttipong, Chuanchom Aumnate, Jitrawee Suk-Em, Jennarong Tungtrongpairoj

Applied Mechanics and Materials · 13.04.2026 · 935 · 229-234

DOI: 10.4028/p-k45jq9 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Mechanics and Materials, online erschienen am 13.04.2026. Verfasst von Peeraphat Suttipong und 3 weiteren Autor:innen. Die Arbeit nennt 15 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

3D printing parameters such as printing temperatures and speeds play a vital role in the melt flow and printability of thermoplastic filaments in fused filament fabrication (FFF) technology. Inappropriate print settings mainly induce incomplete and poor printing quality due to melt flow instability. This research work focused on modeling the melt flow behavior of polylactic acid (PLA) at different printing temperatures and speeds using computer fluid dynamics (CFD) method. The shear stress and viscosity of PLA were investigated by a melt flow indexer (MFI) and rheometer in temperature ranges of 200 - 240 °C. A model of a capillary tube in MFI was set up with an initial condition of rheological properties from the experiment to simulate the hot melt extrusion relating to the melt flowability of PLA filaments. The high shear stress and low viscosity presented at the edge of filaments at every printing condition. Additionally, the shear stress and viscosity decreased linearly when the printing temperature increased, while the shear stress increased when the printing speed increased. The increase in shear stress caused high surface roughness of PLA specimens after printing. The findings can guide the optimization of the FFF 3D printing process to improve surface finish quality.

Zitieren

APA

Suttipong, P., Aumnate, C., Suk-Em, J., & Tungtrongpairoj, J. (2026). Modeling and Investigation of 3D Printing Parameters on the Melt Flow Behavior of Polylactic Acid. Applied Mechanics and Materials, 935, 229-234. https://doi.org/10.4028/p-k45jq9

Vancouver

Suttipong P, Aumnate C, Suk-Em J, Tungtrongpairoj J. Modeling and Investigation of 3D Printing Parameters on the Melt Flow Behavior of Polylactic Acid. Applied Mechanics and Materials. 2026;935:229-234. doi:10.4028/p-k45jq9

BibTeX
@article{Suttipong2026,
  author = {Suttipong, Peeraphat and Aumnate, Chuanchom and Suk-Em, Jitrawee and Tungtrongpairoj, Jennarong},
  title = {Modeling and Investigation of 3D Printing Parameters on the Melt Flow Behavior of Polylactic Acid},
  journal = {Applied Mechanics and Materials},
  year = {2026},
  volume = {935},
  pages = {229--234},
  doi = {10.4028/p-k45jq9}
}
Kostenlos starten →