EUVIMEDEUVIMED entdecken
Crossref

On Gas-Phase Selective Dry Etching in 3D Inflections

Nitin Ingle

Solid State Phenomena · 14.08.2023 · 346 · 14-19

DOI: 10.4028/p-edlao7 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Solid State Phenomena, online erschienen am 14.08.2023. Verfasst von Nitin Ingle. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 13 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Semiconductor industry periodically goes through major transitions in the architectures and materials. The previous such transition was the Logic transition to FinFET and NAND transition to 3DNAND that revolutionized the two devices and accelerated PPAC (power, performance, area, cost) progress. Over the last decade, introduction of EUV lithography has driven the device miniaturization and furthered the cause of PPAC, but with the same architecture. The accelerating technological needs at lower cost point with better power efficiency are driving the current push in fundamental architectural changes and new materials introductions, especially in Logic and DRAM with a transition to 3D structures. This moves the critical etches from traditional RIE to selective isotropic etching. Furthermore, newer materials and requirements of better interfaces in these 3D structures are driving the need for dry selective treatments with good isotropicity and free of damage. This paper will give an overview of the current state of selective dry etch and progress in treatments.

Zitieren

APA

Ingle, N. (2023). On Gas-Phase Selective Dry Etching in 3D Inflections. Solid State Phenomena, 346, 14-19. https://doi.org/10.4028/p-edlao7

Vancouver

Ingle N. On Gas-Phase Selective Dry Etching in 3D Inflections. Solid State Phenomena. 2023;346:14-19. doi:10.4028/p-edlao7

BibTeX
@article{Ingle2023,
  author = {Ingle, Nitin},
  title = {On Gas-Phase Selective Dry Etching in 3D Inflections},
  journal = {Solid State Phenomena},
  year = {2023},
  volume = {346},
  pages = {14--19},
  doi = {10.4028/p-edlao7}
}
Kostenlos starten →