EUVIMEDEUVIMED entdecken
Crossref

The Impact of Final Turning on the SCC Susceptibility of Austenitic Stainless Steel AISI 304 and AISI 321

Marek Kudláč, Mária Dománková, Katarína Bártová, Matúš Gavalec, Dávid Slnek

Solid State Phenomena · 13.03.2026 · 386 · 77-83

DOI: 10.4028/p-3celnj ↗

Kurz gefasst

Fachartikel in der Zeitschrift Solid State Phenomena, online erschienen am 13.03.2026. Verfasst von Marek Kudláč und 4 weiteren Autor:innen. Die Arbeit nennt 8 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Final turning, which is a finishing process for obtaining components with specific precise parameters, affects the integrity of the surface and its properties, whether hardness or surface residual stresses. The synergistic effect of these factors affects the susceptibility of the material, to stress corrosion cracking. In this work, 2 types of austenitic stainless steel, namely AISI 304 and AISI 321, were turned. Tool with positive cutting geometry was used for turning. The cutting parameters that varied were the cutting speed (100 and 250 m.min −1 ) and the tool feed (0.12, 0.2 and 0.3 mm·rev −1 ). The depth of cut was the same for all turnings (0.8 mm). Subsequently, the prepared samples were exposed in MgCl 2 solution based on the ASTM G36 for 96 hours. After this time, the samples were analysed using SEM, where the density of surface cracks was monitored. When comparing the crack density, an increase in density was visible for AISI 304 compared to AISI 321. It was shown that with increasing cutting speed, the density of cracks increased significantly, as well as with increasing tool feed. On the cross-sections the depth and length of the cracks were analysed. Crack depth and length increased with increasing feed too.

Zitieren

APA

Kudláč, M., Dománková, M., Bártová, K., Gavalec, M., & Slnek, D. (2026). The Impact of Final Turning on the SCC Susceptibility of Austenitic Stainless Steel AISI 304 and AISI 321. Solid State Phenomena, 386, 77-83. https://doi.org/10.4028/p-3celnj

Vancouver

Kudláč M, Dománková M, Bártová K, Gavalec M, Slnek D. The Impact of Final Turning on the SCC Susceptibility of Austenitic Stainless Steel AISI 304 and AISI 321. Solid State Phenomena. 2026;386:77-83. doi:10.4028/p-3celnj

BibTeX
@article{Kudl2026,
  author = {Kudláč, Marek and Dománková, Mária and Bártová, Katarína and Gavalec, Matúš and Slnek, Dávid},
  title = {The Impact of Final Turning on the SCC Susceptibility of Austenitic Stainless Steel AISI 304 and AISI 321},
  journal = {Solid State Phenomena},
  year = {2026},
  volume = {386},
  pages = {77--83},
  doi = {10.4028/p-3celnj}
}
Kostenlos starten →