EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Geometry-Based Concept for Automatic Cut Planning and Flattening of Sheet Metal Components

Jannis Korn, Clemens Acksteiner, Sebastian Langula, Christina Guilleaume, Alexander Brosius

Key Engineering Materials · 15.04.2026 · 1049 · 99-106

DOI: 10.4028/p-1l1zvc ↗

Kurz gefasst

Fachartikel in der Zeitschrift Key Engineering Materials, online erschienen am 15.04.2026. Verfasst von Jannis Korn und 4 weiteren Autor:innen. Die Arbeit nennt 12 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Sheet metal components with complex geometries are typically recycled by remelting. Direct remanufacturing necessitates the flattening of parts, which requires the implementation of cuts to facilitate unwinding. The exact positioning of these cuts is a complex planning task, because several influencing factors can be considered, such as material usage, ease of flattening, or minimal forming required. This study presents a geometry-based concept addressing this challenge and demonstrates its use for a test geometry. The finite element method is applied to simulate the flattening process of the resulting sections, and the results are evaluated in terms of planarity and induced plastic strain. The findings of the present work indicate a discernible dependency of results on the selection of the flattening directions. In particular, curved areas impact the induced plastic deformation and springback of flattened sections. This is a crucial consideration when planarity is prioritised over material utilisation.

Zitieren

APA

Korn, J., Acksteiner, C., Langula, S., Guilleaume, C., & Brosius, A. (2026). Geometry-Based Concept for Automatic Cut Planning and Flattening of Sheet Metal Components. Key Engineering Materials, 1049, 99-106. https://doi.org/10.4028/p-1l1zvc

Vancouver

Korn J, Acksteiner C, Langula S, Guilleaume C, Brosius A. Geometry-Based Concept for Automatic Cut Planning and Flattening of Sheet Metal Components. Key Engineering Materials. 2026;1049:99-106. doi:10.4028/p-1l1zvc

BibTeX
@article{Korn2026,
  author = {Korn, Jannis and Acksteiner, Clemens and Langula, Sebastian and Guilleaume, Christina and Brosius, Alexander},
  title = {Geometry-Based Concept for Automatic Cut Planning and Flattening of Sheet Metal Components},
  journal = {Key Engineering Materials},
  year = {2026},
  volume = {1049},
  pages = {99--106},
  doi = {10.4028/p-1l1zvc}
}
Kostenlos starten →