EUVIMEDEUVIMED entdecken
Crossref

Numerical study of aerodynamic drag reduction of a circular cylinder with an inbuilt nozzle

Sarker Ashraful Islam, Farhana Kabir Esheta, Md Mahir Shahriar, Dewan Hasan Ahmed

Metascience in Aerospace · 2024

DOI: 10.3934/mina.2024018 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metascience in Aerospace, 2024. Verfasst von Sarker Ashraful Islam und 3 weiteren Autor:innen. Die Arbeit nennt 39 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Researchers have extensively studied drag reduction because of its impact on a vehicle's fuel economy and structural stability, among other applications. A numerical study was carried out on the two-dimensional flow past a circular cylinder acting as a bluff body. In this case, the converging and diverging nozzles were used as passive flow control devices to reduce the drag coefficient. The subcritical Reynolds number 1×105 was considered for the numerical study using ANSYS Fluent with the k-ω SST as a viscous model. Seven different outlet and inlet diameter ratios, Dout/Din, ranging from 0.2 to 1.4, were considered for the nozzle. The main focus of this research was to find the influence of a nozzle in a circular cylinder on decreasing drag. It was found that both the converging and diverging nozzles can be used in passive mode to reduce the drag coefficient. For the converging nozzle, a jet is formed at the exit of the nozzle, which produces thrust and ultimately reduces the drag coefficient. The flow rate increases through the nozzle with the increase in Dout/Din. This leads to a more extended jet, which fluctuates more because of the flow separation and the inherent nature of the vortex shedding of a circular cylinder. The drag coefficients are reduced by more than 30% in all the simulated cases. However, the drag reduction is more significant for the diverging nozzle and is greatly influenced by Dout/Din. Indeed, more than 38% of drag coefficients are reduced for Dout/Din = 1.4. On the other hand, the vortex shedding frequency is significantly higher for the diverging nozzle. Therefore, converging nozzles have an upper hand over the diverging nozzles. The grid independence test was achieved, and the numerical model was validated with results available in the open literature.

Zitieren

APA

Islam, S. A., Esheta, F. K., Shahriar, M. M., & Ahmed, D. H. (2024). Numerical study of aerodynamic drag reduction of a circular cylinder with an inbuilt nozzle. Metascience in Aerospace. https://doi.org/10.3934/mina.2024018

Vancouver

Islam SA, Esheta FK, Shahriar MM, Ahmed DH. Numerical study of aerodynamic drag reduction of a circular cylinder with an inbuilt nozzle. Metascience in Aerospace. 2024. doi:10.3934/mina.2024018

BibTeX
@article{Islam2024,
  author = {Islam, Sarker Ashraful and Esheta, Farhana Kabir and Shahriar, Md Mahir and Ahmed, Dewan Hasan},
  title = {Numerical study of aerodynamic drag reduction of a circular cylinder with an inbuilt nozzle},
  journal = {Metascience in Aerospace},
  year = {2024},
  doi = {10.3934/mina.2024018}
}
Kostenlos starten →