EUVIMEDSkopri EUVIMED
Video/Audio

Improving Thermoelectric Properties of Bi2Te3 Thin Films By Manganese Co-Sputtering

Angella Th'ng, Nurfarhana Ahmad Musri, Puvaneswaran Chelvanathan, Mohd Sukor Su'ait, Nadhrah Md Yatim, Assayidatul Laila Nor Hairin, Ubaidah Syafiq

Journal of Visualized Experiments · 2026

DOI: 10.3791/71082 ↗

At a glance

Video/Audio in Journal of Visualized Experiments, 2026. Written by Angella Th'ng and 6 co-authors. Institution: Solar Energy Research Institute (SERI), Universiti Kebangsaan Malaysia; p153906@siswa.ukm.edu.my. Major MEDLINE topics: Manganese, Bismuth, Tellurium. 66 references.

AstrattSubjectsDettalji biblijografiċiCiteRelated studies

Abstract (original language)

Bi2Te3 remains a benchmark n-type thermoelectric (TE) material for low-temperature energy conversion, but its small band gap can reduce efficiency because of thermally generated parasitic carriers. Elemental doping has been explored to improve TE performance, although systematic studies on manganese (Mn)-doped Bi2Te3 thin films remain limited. In this study, a radiofrequency magnetron co-sputtering workflow was used to fabricate Mn-doped Bi2Te3 thin films by varying Mn target power while maintaining constant Bi2Te3 deposition conditions. Structural, microstructural, compositional, and TE transport properties were evaluated using X-ray diffraction, field-emission scanning electron microscopy, energy-dispersive X-ray spectroscopy, and temperature-dependent transport measurements. X-ray diffraction confirmed retention of the rhombohedral Bi2Te3 phase with a preferred (015) orientation, while peak shifts toward higher 2θ values were consistent with Mn-related lattice contraction. All films exhibited negative Seebeck coefficients, confirming n-type conduction. Increasing Mn doping enhanced the magnitude of the Seebeck coefficient but also increased electrical resistivity, demonstrating a transport tradeoff. The film deposited at 5 W Mn power achieved the highest power factor of 529.33 µW m-1 K-2 at 523 K because of its low resistivity combined with adequate thermopower. These results demonstrate that moderate Mn incorporation can improve the power-factor-related performance of Bi2Te3 thin films within the measured temperature range.

Subjects

MeSH terms (MEDLINE)

ManganeseBismuthTellurium

Substances

ManganeseBismuthTelluriumbismuth telluride

Authors and institutions

  • Solar Energy Research Institute (SERI), Universiti Kebangsaan Malaysia; p153906@siswa.ukm.edu.my.
  • Solar Energy Research Institute (SERI), Universiti Kebangsaan Malaysia.
  • Faculty of Science and Technology, Universiti Sains Islam Malaysia.
  • Department of Manufacturing and Materials Engineering, Kulliyyah of Engineering, International Islamic University Malaysia.
  • Solar Energy Research Institute (SERI), Universiti Kebangsaan Malaysia; ubaidahsyafiq@ukm.edu.my.

Cite

APA

Th'ng, A., Ahmad Musri, N., Chelvanathan, P., Su'ait, M. S., Md Yatim, N., Nor Hairin, A. L., & Syafiq, U. (2026). Improving Thermoelectric Properties of Bi2Te3 Thin Films By Manganese Co-Sputtering. Journal of Visualized Experiments. https://doi.org/10.3791/71082

Vancouver

Th'ng A, Ahmad Musri N, Chelvanathan P, Su'ait MS, Md Yatim N, Nor Hairin AL, et al. Improving Thermoelectric Properties of Bi2Te3 Thin Films By Manganese Co-Sputtering. Journal of Visualized Experiments. 2026. doi:10.3791/71082

BibTeX
@article{Thng2026,
  author = {Th'ng, Angella and Ahmad Musri, Nurfarhana and Chelvanathan, Puvaneswaran and Su'ait, Mohd Sukor and Md Yatim, Nadhrah and Nor Hairin, Assayidatul Laila and Syafiq, Ubaidah},
  title = {Improving Thermoelectric Properties of Bi2Te3 Thin Films By Manganese Co-Sputtering},
  journal = {Journal of Visualized Experiments},
  year = {2026},
  doi = {10.3791/71082}
}
Start for free →