EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Investigation of the Process-Induced Defects in Metal Fused Deposition Modeling Process for Ultrafuse 316L Stainless Steel

Abbas Raza, Syed Waqar Ahmed, Adeel Hassan, Khurram Altaf, Hongyu Wei, Ghulam Hussain

Digital Manufacturing Technology · 2023

DOI: 10.37256/dmt.3220233447 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Digital Manufacturing Technology, 2023. Verfasst von Abbas Raza und 5 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The current article presents a case study of the defects that can occur in the metal fused deposition modeling (FDM) process, a popular additive manufacturing technique for producing metal parts. The metal parts of Ultrafuse 316L SS filament (a metal-polymer composite) were produced and then subjected to de-binding and sintering. The defects in the brown parts (after de-binding) and the silver parts (after sintering) were analyzed carefully. The main defects detected include brittleness, cracks, blisters, layer delamination, part deformation, and porosity. Further, the formation of these defects was found to be influenced by the process parameters such as heating rate, holding time, temperature, and atmosphere. The analysis of these effects suggests to use furnace temperature of 310 °C, heating rate of 1 °C/min and holding time of around 10 to 15 minutes to minimize the defects. As regard to the atmosphere, vacuum is preferred over other environments to produce parts with reduced defects and enhanced quality.

Zitieren

APA

Raza, A., Ahmed, S. W., Hassan, A., Altaf, K., Wei, H., & Hussain, G. (2023). Investigation of the Process-Induced Defects in Metal Fused Deposition Modeling Process for Ultrafuse 316L Stainless Steel. Digital Manufacturing Technology. https://doi.org/10.37256/dmt.3220233447

Vancouver

Raza A, Ahmed SW, Hassan A, Altaf K, Wei H, Hussain G. Investigation of the Process-Induced Defects in Metal Fused Deposition Modeling Process for Ultrafuse 316L Stainless Steel. Digital Manufacturing Technology. 2023. doi:10.37256/dmt.3220233447

BibTeX
@article{Raza2023,
  author = {Raza, Abbas and Ahmed, Syed Waqar and Hassan, Adeel and Altaf, Khurram and Wei, Hongyu and Hussain, Ghulam},
  title = {Investigation of the Process-Induced Defects in Metal Fused Deposition Modeling Process for Ultrafuse 316L Stainless Steel},
  journal = {Digital Manufacturing Technology},
  year = {2023},
  doi = {10.37256/dmt.3220233447}
}
Kostenlos starten →