Experimental investigation of CF8 stainless steel impeller quality using PLA-based fused deposition modeling-assisted investment casting
Materials Research Express · 01.01.2025 · 12 (1) · 016508
DOI: 10.1088/2053-1591/ada5be ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials Research Express, online erschienen am 15.01.2025. Verfasst von Margi Shah und 4 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: King Saud University.
Abstract (Originalsprache)
The conventional Investment Casting (IC) process is extensively used for manufacturing parts with intricate shapes and complex geometries. However, its drawbacks include long cycle times and costly tooling, making it ideal for mass production but inefficient for frequent design changes, small batch production, or customized products. To address these challenges, a novel hybrid method known as Fused Deposition Modeling Assisted Investment Casting (FDMAIC) has been developed. In FDMAIC, the wax pattern is replaced by an FDM-printed pattern, while all other steps follow the conventional IC process. In this study, a semi-open impeller for a centrifugal pump was produced using FDMAIC, with Polylactic Acid (PLA) as the pattern material and CF8 for casting. Dimensional accuracy and surface roughness, key indicators of quality, were evaluated at both the printing and casting stages. Critical dimensions such as outer and inner diameters, shroud and blade thicknesses, and total height were measured, along with surface roughness at the shroud and blade surfaces. In the final cast, maximum dimensional deviation was observed in Outer diameter(−2.408 mm), and minimum dimensional deviation was observed in total height(−0.169 mm). The surface roughness values obtained at the shroud and blade surface of the final cast were 4.64 μm 6.67 μm, respectively. Microstructure and hardness testing were also performed on the FDMAIC impeller to validate the process. The results provide detailed insights into the feasibility of FDMAIC and suggest areas for further improvement.
Förderung
- King Saud University
Zitieren
APA
Shah, M., Patel, D., Pande, S., Abidi, M. H., & Alasim, F. (2025). Experimental investigation of CF8 stainless steel impeller quality using PLA-based fused deposition modeling-assisted investment casting. Materials Research Express, 12(1), 016508. https://doi.org/10.1088/2053-1591/ada5be
Vancouver
Shah M, Patel D, Pande S, Abidi MH, Alasim F. Experimental investigation of CF8 stainless steel impeller quality using PLA-based fused deposition modeling-assisted investment casting. Materials Research Express. 2025;12(1):016508. doi:10.1088/2053-1591/ada5be
BibTeX
@article{Shah2025,
author = {Shah, Margi and Patel, Dhiren and Pande, Sarang and Abidi, Mustufa Haider and Alasim, Fahad},
title = {Experimental investigation of CF8 stainless steel impeller quality using PLA-based fused deposition modeling-assisted investment casting},
journal = {Materials Research Express},
year = {2025},
volume = {12},
number = {1},
pages = {016508},
doi = {10.1088/2053-1591/ada5be}
}
EUVIMED