Additive Manufacturing of Cupric Oxide via Direct Ink Writing
Memoria Investigaciones en Ingeniería · 11.06.2026 · (30) · 14-29
DOI: 10.36561/ing.30.3 ↗Kurz gefasst
Fachartikel in der Zeitschrift Memoria Investigaciones en Ingeniería, online erschienen am 11.06.2026. Verfasst von Muhammad Ali und 4 weiteren Autor:innen. Die Arbeit nennt 56 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
The DIW approach offers numerous benefits, including expedited prototyping, cost-effectiveness, reduced waste in manufacturing, and enhanced design flexibility. It's currently a popular production method for building materials and has great potential for porous and electronic materials. In this study, porous cupric oxide (CuO) ceramics were fabricated using a direct ink writing (DIW) approach based on a copper particle–laden aqueous precursor. The ink formulation was optimized to achieve stable extrusion and crack-free green bodies, yielding a final composition of 68.0 wt% Cu, 31.3 wt% water, and 0.6 wt% CMC. Following oxidation and sintering in air, the printed structures exhibited a bulk density of 3.60 ± 0.20 g cm⁻³ and a corresponding theoretical porosity of 43.7 ± 0.9%. X-ray diffraction confirmed nearly phase-pure monoclinic CuO with no detectable Cu or Cu₂O residues. The printed components exhibited an interconnected, porous microstructure and a four-point-probe resistivity of 10.5 ± 0.3 Ω·m at 25 °C, reflecting the influence of high porosity on charge transport. The DIW route demonstrated here provides a controllable pathway for producing porous CuO architectures with tunable microstructure and moderate electrical conductivity. These characteristics suggest potential applicability in gas filtration, catalytic supports, and electrochemical sensing; however, device-level validation is still required to fully assess functional performance.
Zitieren
APA
Ali, M., Khan, S. A., Shah, A., Najib, A., & Hussain, A. (2026). Additive Manufacturing of Cupric Oxide via Direct Ink Writing. Memoria Investigaciones en Ingeniería, 14-29. https://doi.org/10.36561/ing.30.3
Vancouver
Ali M, Khan SA, Shah A, Najib A, Hussain A. Additive Manufacturing of Cupric Oxide via Direct Ink Writing. Memoria Investigaciones en Ingeniería. 2026:14-29. doi:10.36561/ing.30.3
BibTeX
@article{Ali2026,
author = {Ali, Muhammad and Khan, Shaheryar A. and Shah, Aqueel and Najib, Antash and Hussain, Abbas},
title = {Additive Manufacturing of Cupric Oxide via Direct Ink Writing},
journal = {Memoria Investigaciones en Ingeniería},
year = {2026},
number = {30},
pages = {14--29},
doi = {10.36561/ing.30.3}
}
EUVIMED