MECHANICAL PERFORMANCE OF LAYERED PLA–TPU COMPOSITES USING MULTI-MATERIAL ADDITIVE MANUFACTURING
Journal of Engineering & Technological Advances · 31.12.2025 · 10 (2) · 122-142
DOI: 10.35934/segi.v10i2.171 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Engineering & Technological Advances, online erschienen am 31.12.2025. Verfasst von Mark Armstrong und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Abstract (Originalsprache)
This study investigates the tensile performance of layered PLA–TPU composites produced by multi-material additive manufacturing (MMAM) via fused deposition modelling (FDM). Although PLA–TPU is a widely used rigid–flexible polymer pair, tensile performance is often limited by weak interfacial bonding and limited evidence on how layer thickness, material ratio, and stacking sequence influence load transfer and fracture. A screening study of 30 layered specimens quantified the effects of layer thickness (0.1 and 0.2 mm), material ratio (33:67, 50:50, and 67:33 PLA:TPU), and stack order on apparent stiffness, ultimate tensile strength (UTS), elongation, and post-fracture failure features. PLA-rich configurations achieved high strength (up to 33.5 MPa) with semi-ductile failure behaviour, whereas TPU-rich configurations showed large elongations (up to 298%) but lower strength (12–14 MPa). Across the configurations tested, a 67/33 PLA/TPU laminate provided the best balance of strength and ductility, reaching an average UTS of 33.5 MPa with 7.7% elongation, consistent with improved interlayer load transfer despite the intrinsic surface-energy disparity between PLA and TPU. Overall, the results demonstrate that MMAM by FDM can combine dissimilar thermoplastics within a single build to achieve an adaptive mechanical response, while interfacial optimisation remains the primary constraint for further performance gains.
Zitieren
APA
Armstrong, M., Ruwais, A., & Naveed, N. (2025). MECHANICAL PERFORMANCE OF LAYERED PLA–TPU COMPOSITES USING MULTI-MATERIAL ADDITIVE MANUFACTURING. Journal of Engineering & Technological Advances, 10(2), 122-142. https://doi.org/10.35934/segi.v10i2.171
Vancouver
Armstrong M, Ruwais A, Naveed N. MECHANICAL PERFORMANCE OF LAYERED PLA–TPU COMPOSITES USING MULTI-MATERIAL ADDITIVE MANUFACTURING. Journal of Engineering & Technological Advances. 2025;10(2):122-142. doi:10.35934/segi.v10i2.171
BibTeX
@article{Armstrong2025,
author = {Armstrong, Mark and Ruwais, Akeeb and Naveed, Nida},
title = {MECHANICAL PERFORMANCE OF LAYERED PLA–TPU COMPOSITES USING MULTI-MATERIAL ADDITIVE MANUFACTURING},
journal = {Journal of Engineering & Technological Advances},
year = {2025},
volume = {10},
number = {2},
pages = {122--142},
doi = {10.35934/segi.v10i2.171}
}
EUVIMED