EUVIMEDEUVIMED entdecken
Crossref

Effect of 3D Printing Parameters on the Flexural Performance of Laminated Structures: A Taguchi and ANOVA-Based Approach

Arif Karadağ, Osman Ülkir

Black Sea Journal of Engineering and Science · 15.11.2026 · 9 (6) · 2924-2931

DOI: 10.34248/bsengineering.1988015 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Black Sea Journal of Engineering and Science, online erschienen am 15.11.2026. Verfasst von Arif Karadağ und 1 weiteren Autor:innen. Die Arbeit nennt 16 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The influence of important fused deposition modelling (FDM) parameters, including infill pattern, printing speed and wall thickness, on the flexural behaviors of multi-layered laminated polymer specimens, was investigated in this study. However, the literature remains limited regarding data on the flexural behavior of multi-material laminated FDM structures. To address this gap, the study develops a new three-layer laminated structure (PLA-ABS-CF/PLA) and provides statistical validation using Taguchi design and analysis of variance (ANOVA). The samples were manufactured in a three-layer structure consisting of PLA on the top, ABS in the core, and carbon fiber-reinforced PLA (CF/PLA) on the bottom. Nine experimental runs were designed according to a Taguchi L9 orthogonal array to evaluate the effect of process parameters on flexural stress. The experimental results showed that the highest flexural stress of 78.66 MPa was achieved with a ZigZag infill pattern, a printing speed of 40 mm/s, and a wall thickness of 2 mm. In the analysis of the signal-to-noise (S/N) ratio, the printing speed was found to be the most important parameter, followed by the infill pattern, with the wall thickness having a relatively minor effect. The ANOVA results showed that the contribution of printing speed to the total variation in flexural stress was 91.8% (p = 0.011) and wall thickness was statistically insignificant (p = 0.075). Three-dimensional surface response plots were used to visualize interaction effects between the parameters. Overall, results show that optimized printing speed and infill design significantly improve the flexural performance of laminated multi-material structures manufactured by FDM.

Zitieren

APA

Karadağ, A., & Ülkir, O. (2026). Effect of 3D Printing Parameters on the Flexural Performance of Laminated Structures: A Taguchi and ANOVA-Based Approach. Black Sea Journal of Engineering and Science, 9(6), 2924-2931. https://doi.org/10.34248/bsengineering.1988015

Vancouver

Karadağ A, Ülkir O. Effect of 3D Printing Parameters on the Flexural Performance of Laminated Structures: A Taguchi and ANOVA-Based Approach. Black Sea Journal of Engineering and Science. 2026;9(6):2924-2931. doi:10.34248/bsengineering.1988015

BibTeX
@article{Karada2026,
  author = {Karadağ, Arif and Ülkir, Osman},
  title = {Effect of 3D Printing Parameters on the Flexural Performance of Laminated Structures: A Taguchi and ANOVA-Based Approach},
  journal = {Black Sea Journal of Engineering and Science},
  year = {2026},
  volume = {9},
  number = {6},
  pages = {2924--2931},
  doi = {10.34248/bsengineering.1988015}
}
Kostenlos starten →