Experimental Study on Blocky Cuttings Transport in Shale Gas Horizontal Wells
Water · 30.03.2025 · 17 (7) · 1016
DOI: 10.3390/w17071016 ↗Kurz gefasst
Fachartikel in der Zeitschrift Water, online erschienen am 30.03.2025. Verfasst von Di Yao und 3 weiteren Autor:innen. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 43 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, National Key R&D Program of China.
Abstract (Originalsprache)
The widespread application of horizontal drilling technology has significantly enhanced the development efficiency of unconventional resources, particularly shale gas, by overcoming key technical challenges in reservoir exploitation. However, wellbore instability remains a critical challenge during shale gas horizontal drilling, as borehole wall collapse often results in the accumulation of large-sized cuttings (or blocky cuttings), increasing the risk of stuck pipe incidents. In this study, a large-scale circulating loop experimental system was developed to investigate the hydrodynamic behavior of blocky cuttings transport under the influence of multiple factors, including rate of penetration (ROP), well inclination, flow rate, drilling fluid rheology, and block size. The experimental results reveal that when ROP exceeds 15 m/h, the annular solid-phase concentration increases non-linearly. At a well inclination of 60°, the axial and radial components of gravitational force reach a dynamic equilibrium, resulting in the maximum cuttings bed height. To enhance cuttings transport efficiency and mitigate deposition, a minimum flow rate of 35 L/s and a drill pipe rotation speed of 90 rpm are required to maintain sufficient turbulence in the annulus. Drilling fluid plastic viscosity (PV) in the range of 65–75 mPa·s optimizes suspension efficiency while minimizing circulating pressure loss. Additionally, increasing fluid density enhances the transport efficiency of large blocky cuttings. A drill pipe rotation speed of 80 rpm is recommended to prevent the formation of sand-wave-like cuttings beds. These findings provide valuable hydrodynamic insights and practical guidelines for optimizing hole-cleaning strategies, ensuring safer and more efficient drilling operations in shale gas horizontal wells.
Förderung
- National Natural Science Foundation of China
- National Key R&D Program of China
Zitieren
APA
Yao, D., Sun, X., Zhang, H., & Qu, J. (2025). Experimental Study on Blocky Cuttings Transport in Shale Gas Horizontal Wells. Water, 17(7), 1016. https://doi.org/10.3390/w17071016
Vancouver
Yao D, Sun X, Zhang H, Qu J. Experimental Study on Blocky Cuttings Transport in Shale Gas Horizontal Wells. Water. 2025;17(7):1016. doi:10.3390/w17071016
BibTeX
@article{Yao2025,
author = {Yao, Di and Sun, Xiaofeng and Zhang, Huixian and Qu, Jingyu},
title = {Experimental Study on Blocky Cuttings Transport in Shale Gas Horizontal Wells},
journal = {Water},
year = {2025},
volume = {17},
number = {7},
pages = {1016},
doi = {10.3390/w17071016}
}
EUVIMED