EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Development of a High-Frequency, High-Temperature Class-A Amplifier Based on a Silicon Carbide Static Induction Transistor

Maximilian C Scardelletti iD, Jonathon R Grgat, Christian A Zorman iD

Sensors · 08.06.2026 · 26 (12) · 3646

DOI: 10.3390/s26123646 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 08.06.2026. Verfasst von Maximilian C Scardelletti und 2 weiteren Autor:innen. Beteiligte Einrichtung: Communications and Intelligent Design Division at NASA Glenn Research Center, Cleveland, OH 44135, USA. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 18 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Glenn Research Center, U.S. Department of Defense.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper reports the development of a Class-A amplifier that operates at 50 MHz and 400 °C. The amplifier utilizes a commercially available 4H-SiC static induction transistor (SIT) as the active device and incorporates input/output-matching networks to optimize amplifier operation and DC bias networks, which comprise thin-film spiral inductors, metal–insulator–metal (MIM) capacitors, and thick-film chip resistors. All passive components were tested at frequency and temperature prior to amplifier development and are reported. A small-signal SiC SIT model that was developed in Keysight’s Advanced Design System (ADS 2023) software suite was used to design and optimize the amplifier’s performance. The SiC SIT amplifier’s S-parameters were recorded for frequencies between 20 and 100 MHz over a temperature range of 25 °C to 400 °C, exhibiting a gain (S21) of approximately 15.8 and 5.80 dB at 25 °C and 400 °C, respectively. The input and output reflection coefficients at 50 MHz and 400 °C were −18.5 and −15.2 dB, respectively. The noise figure and phase noise were measured at temperatures between 25 °C and 400 °C. At 50 MHz, the noise figure increased by only 21% over the temperature range, while the 1 kHz offset of the phase noise remained below −110 dBc/Hz. The stability factor, K, calculated using both measured and simulated data, demonstrates unconditional stability over the frequency range at 400 °C. Lastly, the 1 dB compression point was measured at 50 MHz and 400 °C with an approximated output of 9.5 dB. Simulated and measured results are presented and show the model is within 10% error at 400 °C.

Schlagwörter

Stichwörter der Autor:innen

Class-A amplifierhigh frequencyhigh temperaturesilicon carbidestatic induction transistor

Autor:innen und Institutionen

  • Communications and Intelligent Design Division at NASA Glenn Research Center, Cleveland, OH 44135, USA.
  • Department of Electrical, Computer and Systems Engineering, Case Western Reserve University, Cleveland, OH 44106, USA.

ORCID-Profile: Maximilian C Scardelletti, Christian A Zorman

Förderung

  • Glenn Research Center
  • U.S. Department of Defense

Zitieren

APA

Scardelletti, M. C., Grgat, J. R., & Zorman, C. A. (2026). Development of a High-Frequency, High-Temperature Class-A Amplifier Based on a Silicon Carbide Static Induction Transistor. Sensors, 26(12), 3646. https://doi.org/10.3390/s26123646

Vancouver

Scardelletti MC, Grgat JR, Zorman CA. Development of a High-Frequency, High-Temperature Class-A Amplifier Based on a Silicon Carbide Static Induction Transistor. Sensors. 2026;26(12):3646. doi:10.3390/s26123646

BibTeX
@article{Scardelletti2026,
  author = {Scardelletti, Maximilian C and Grgat, Jonathon R and Zorman, Christian A},
  title = {Development of a High-Frequency, High-Temperature Class-A Amplifier Based on a Silicon Carbide Static Induction Transistor},
  journal = {Sensors},
  year = {2026},
  volume = {26},
  number = {12},
  pages = {3646},
  doi = {10.3390/s26123646}
}
Kostenlos starten →