Autonomous Concrete Crack Monitoring Using a Mobile Robot with a 2-DoF Manipulator and Stereo Vision Sensors
Sensors · 03.10.2025 · 25 (19) · 6121
DOI: 10.3390/s25196121 ↗Kurz gefasst
Fachartikel in der Zeitschrift Sensors, online erschienen am 03.10.2025. Verfasst von Seola Yang und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Civil and Environmental Engineering, Hanbat National University, Daejeon 34158, Republic of Korea. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 58 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Crack monitoring in concrete structures is essential to maintaining structural integrity. Therefore, this paper proposes a mobile ground robot equipped with a 2-DoF manipulator and stereo vision sensors for autonomous crack monitoring and mapping. To facilitate crack detection over large areas, a 2-DoF motorized manipulator providing linear and rotational motions, with a stereo vision sensor mounted on the end effector, was deployed. In combination with a manual rotation plate, this configuration enhances accessibility and expands the field of view for crack monitoring. Another stereo vision sensor, mounted at the front of the robot, was used to acquire point cloud data of the surrounding environment, enabling tasks such as SLAM (simultaneous localization and mapping), path planning and following, and obstacle avoidance. Cracks are detected and segmented using the deep learning algorithms YOLO (You Only Look Once) v6-s and SFNet (Semantic Flow Network), respectively. To enhance the performance of crack segmentation, synthetic image generation and preprocessing techniques, including cropping and scaling, were applied. The dimensions of cracks are calculated using point clouds filtered with the median absolute deviation method. To validate the performance of the proposed crack-monitoring and mapping method with the robot system, indoor experimental tests were performed. The experimental results confirmed that, in cases of divided imaging, the crack propagation direction was predicted, enabling robotic manipulation and division-point calculation. Subsequently, total crack length and width were calculated by combining reconstructed 3D point clouds from multiple frames, with a maximum relative error of 1%.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Civil and Environmental Engineering, Hanbat National University, Daejeon 34158, Republic of Korea.
- Department of Civil Engineering, The University of Texas at Arlington, Arlington, TX 76019, USA.
- Department of Mechanical Engineering, Gwangju Institute of Science and Technology, Gwangju 61005, Republic of Korea.
ORCID-Profile: Seola Yang, Daeik Jang, Jonghyeok Kim, Haemin Jeon
Zitieren
APA
Yang, S., Jang, D., Kim, J., & Jeon, H. (2025). Autonomous Concrete Crack Monitoring Using a Mobile Robot with a 2-DoF Manipulator and Stereo Vision Sensors. Sensors, 25(19), 6121. https://doi.org/10.3390/s25196121
Vancouver
Yang S, Jang D, Kim J, Jeon H. Autonomous Concrete Crack Monitoring Using a Mobile Robot with a 2-DoF Manipulator and Stereo Vision Sensors. Sensors. 2025;25(19):6121. doi:10.3390/s25196121
BibTeX
@article{Yang2025,
author = {Yang, Seola and Jang, Daeik and Kim, Jonghyeok and Jeon, Haemin},
title = {Autonomous Concrete Crack Monitoring Using a Mobile Robot with a 2-DoF Manipulator and Stereo Vision Sensors},
journal = {Sensors},
year = {2025},
volume = {25},
number = {19},
pages = {6121},
doi = {10.3390/s25196121}
}
EUVIMED