EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Microwave Gas Sensors Based on Electrodeposited Polypyrrole–Nickel Phthalocyanine Hybrid Films

Ileana-Alexandra Pavel iD, Alexis Lasserre, Léo Simon, Jérôme Rossignol, Sophie Lakard, Didier Stuerga, Boris Lakard iD

Sensors · 13.06.2023 · 23 (12) · 5550

DOI: 10.3390/s23125550 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 13.06.2023. Verfasst von Ileana-Alexandra Pavel und 6 weiteren Autor:innen. Beteiligte Einrichtung: UTINAM-UMR CNRS 6213, Université de Franche-Comté, 25030 Besançon, France. Hauptthemen laut MEDLINE: Polymers, Pyrroles. Die Arbeit wurde bisher 12-mal zitiert (Crossref) und nennt 54 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Regional Council of Bourgogne Franche-Comté.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Previous studies have shown that the incorporation of sulfonated metallophthalocyanines into sensitive sensor materials can improve electron transfer and thus species detection. Herein, we propose a simple and easy alternative to the use of generally expensive sulfonated phthalocyanines by electropolymerizing polypyrrole together with nickel phthalocyanine in the presence of an anionic surfactant. The addition of the surfactant not only helps the incorporation of the water-insoluble pigment into the polypyrrole film, but the obtained structure has increased hydrophobicity, which is a key property for developing efficient gas sensors with low sensitivity to water. The obtained results show the effectiveness of the materials tested for the detection of ammonia in the range of 100 to 400 ppm. It is shown by comparing the microwave sensor responses that the film without nickel phthalocyanine (hydrophilic) produces greater variations than the film with nickel phthalocyanine (hydrophobic). These results are consistent with the expected results since the hydrophobic film is not very sensitive to residual ambient water and therefore does not interfere with the microwave response. However, although this excess response is usually a handicap, as it is a source of drift, in these experiments the microwave response shows great stability in both cases.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

PolymersPyrrolesNickelMicrowavesSurface-Active AgentsAlkanesulfonatesIsoindoles

Stichwörter der Autor:innen

ammoniaconducting polymersgas sensormicrowave transductionphthalocyanine

Substanzen

PolymersPyrrolesNickelSurface-Active AgentsAlkanesulfonatespolypyrrolephthalocyanineIsoindoles

Autor:innen und Institutionen

  • UTINAM-UMR CNRS 6213, Université de Franche-Comté, 25030 Besançon, France.
  • GERM, Laboratoire Interdisciplinaire Carnot de Bourgogne, Department Interfaces, UMR CNRS 6303, UB, 21078 Dijon, France.

ORCID-Profile: Ileana-Alexandra Pavel, Boris Lakard

Förderung

  • Regional Council of Bourgogne Franche-Comté

Zitieren

APA

Pavel, I. A., Lasserre, A., Simon, L., Rossignol, J., Lakard, S., Stuerga, D., & Lakard, B. (2023). Microwave Gas Sensors Based on Electrodeposited Polypyrrole–Nickel Phthalocyanine Hybrid Films. Sensors, 23(12), 5550. https://doi.org/10.3390/s23125550

Vancouver

Pavel IA, Lasserre A, Simon L, Rossignol J, Lakard S, Stuerga D, et al. Microwave Gas Sensors Based on Electrodeposited Polypyrrole–Nickel Phthalocyanine Hybrid Films. Sensors. 2023;23(12):5550. doi:10.3390/s23125550

BibTeX
@article{Pavel2023,
  author = {Pavel, Ileana-Alexandra and Lasserre, Alexis and Simon, Léo and Rossignol, Jérôme and Lakard, Sophie and Stuerga, Didier and Lakard, Boris},
  title = {Microwave Gas Sensors Based on Electrodeposited Polypyrrole–Nickel Phthalocyanine Hybrid Films},
  journal = {Sensors},
  year = {2023},
  volume = {23},
  number = {12},
  pages = {5550},
  doi = {10.3390/s23125550}
}
Kostenlos starten →