Development and Investigation of High-Temperature Ultrasonic Measurement Transducers Resistant to Multiple Heating–Cooling Cycles
Sensors · 07.02.2023 · 23 (4) · 1866
DOI: 10.3390/s23041866 ↗Kurz gefasst
Fachartikel in der Zeitschrift Sensors, online erschienen am 07.02.2023. Verfasst von Vaida Vaskeliene und 4 weiteren Autor:innen. Beteiligte Einrichtung: Ultrasound Research Institute, Kaunas University of Technology, Barsausko St. 59, LT-51368 Kaunas, Lithuania. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 27 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Usually for non-destructive testing at high temperatures, ultrasonic transducers made of PZT and silver electrodes are used, but this could lead to damage to or malfunction of the ultrasonic transducer due to poor adhesion between PZT and silver. Soldering is one of the most common types of bonding used for individual parts of ultrasonic transducers (protector, backing, matching layer, etc.), but silver should be protected using additional metal layers (copper) due to its solubility in solder. A mathematical modelling could help to predict if an ultrasonic transducer was manufactured well and if it could operate up to 225 °C. The observed von Mises stresses were very high and concentrated in metal layers (silver and copper), which could lead to disbonding under long-term cyclic temperature loads. This paper presents a multilayer ultrasonic transducer (PZT, silver electrodes, copper layers, backing), which was heated evenly from room temperature to 225 °C and then cooled down. In the B-scan, it was observed that the amplitude of the reflected signal from the bottom of the sample decreased with an increase in temperature. However, after six heating–cooling cycles, the results repeated themselves and no signs of fatigue were noticed. This ultrasonic transducer was well manufactured and could be used for non-destructive testing when the environment temperature changes in cycles up to 225 °C.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Ultrasound Research Institute, Kaunas University of Technology, Barsausko St. 59, LT-51368 Kaunas, Lithuania.
ORCID-Profile: Vaida Vaskeliene, Egidijus Zukauskas
Zitieren
APA
Vaskeliene, V., Sliteris, R., Kazys, R. J., Zukauskas, E., & Mazeika, L. (2023). Development and Investigation of High-Temperature Ultrasonic Measurement Transducers Resistant to Multiple Heating–Cooling Cycles. Sensors, 23(4), 1866. https://doi.org/10.3390/s23041866
Vancouver
Vaskeliene V, Sliteris R, Kazys RJ, Zukauskas E, Mazeika L. Development and Investigation of High-Temperature Ultrasonic Measurement Transducers Resistant to Multiple Heating–Cooling Cycles. Sensors. 2023;23(4):1866. doi:10.3390/s23041866
BibTeX
@article{Vaskeliene2023,
author = {Vaskeliene, Vaida and Sliteris, Reimondas and Kazys, Rymantas Jonas and Zukauskas, Egidijus and Mazeika, Liudas},
title = {Development and Investigation of High-Temperature Ultrasonic Measurement Transducers Resistant to Multiple Heating–Cooling Cycles},
journal = {Sensors},
year = {2023},
volume = {23},
number = {4},
pages = {1866},
doi = {10.3390/s23041866}
}
EUVIMED